Customer Reviews for Powerbuilt 3/8 in. and 1/2 in. Dual Drive Torque Wrench

Seems to work fine. I have nothing to check how accurate it is. I like the 2 sided drive. Adjusting it is a bit hard while turning it to the upper ranges. Good enough for the few times a year I'll use it.

The wrench does what it is supposed to. I like the convenience of both drives on the same tool.

this is a good buy if you are looking for a torque ranch with upper limit to 150 lb-ft.

Got this Torque Wrench and used it immediately.. Replaced the head gaskets on my car and had to torque down the head bolts. and it did what it was supposed to. Just wish it had a case.

Do not purchase this product. It does not work. I broke two intake manifold bolts because the torque calibration is way, way off. Spend the extra $40-$50 to get a decent wrench.

There's not much to say. It's a torque wrench. I assume the torque values are accurate. I bought it to torque expensive aluminum wheels on a classic Mercedes. Seems to work.

The axiom "you get what you pay for" seems appropriate here. The item was delivered promptly and appeared to b fine but whenI attempted to adjust the poundage in accordance with the instructions, the adjustment screw at the bottom of the item came off / broke off. I dont know if it was a manufacturing defect or this one was defective and got past quality control. It was returned to Home Depot without any problem.

Decent torque wrench for weekend jobs. Doesn't come with a case to store the wrench in like most torque wrenches. If this isn't an issue for you, then it's a decent buy. Otherwise, there are other alternatives that do offer a case with the wrench.

I like the Torque wrench a lot, but I wish it came in a case to protect it. I would not have minded to pay $5.00 more for a plastic clam shell case. Other then the lack of case I like it.

Returned product because it was too big for the job I had bought it for.