A: The top of the wave of the corrugation is 1/2" high.
by|Apr 5, 2024
Q:Would these along with wooden posts be good to make a roof over dog cages?
by|Apr 3, 2024
1 Answer
Answer This Question
A: As long as the install guidelines are followed that are set forth in our blue book install guide with regards to minimum slope and span conditions there shouldn’t be an issue for using the panels for this application.
by|Apr 15, 2024
Q:Can I use these as a privacy wall attaching it across one side of my metal gazebo which is 12' wide about 6 ft high.I was going to use about 3 of these and attach them horizontal attaching only to the 4"x4" post of the gazebo. Will these hold w/I bending?
by|Feb 6, 2024
1 Answer
Answer This Question
A: The panels are intended to attach into framing members that are 24” apart to adequately resist wind and other loads applied to the panels.
by|Feb 9, 2024
Q:What is the normal overlap? Are there skylights that could be used in conjunction with these panels?
by|Nov 27, 2023
1 Answer
Answer This Question
A: Normal overlap is 1 3/4" . As far as skylights you would have to check the Manufacture of the skylights to see if they have a installation procedure for metal corrugated roofing.
by|Mar 31, 2024
1 found this answer helpful
Q:can I make these into a round tube sunk in the ground?
by|Nov 4, 2023
2 Answers
Answer This Question
A: Purchase a galvanized culvert pipe that is ready-made and fit for ground contact, sometimes you must buy the proper materials to do the job correctly.
by|Dec 28, 2023
A: I can not answer this as it is not what the product was intended. If put into ground would cause corrosion of the product.
by|Nov 6, 2023
Q:What is the rib height?
by|Oct 16, 2023
1 Answer
Answer This Question
A: The rib height is 1/2".
by|Nov 4, 2023
1 found this answer helpful
Q:What gauge steel is this?
by|Sep 28, 2023
2 Answers
Answer This Question
A: Gauge is not thickness in inches. According to conversion charts 30 gauge (thinnest listed on the chart I found) is .0157inches which means these panels, which are said to be 0.01inches are very thin indeed. {Of note, the lower gauge# = thicker}
by|Oct 23, 2023
A: Hi JayM.
Thank you for shopping at The Home Depot.
According to the product specifications the gauge of Galvanized Metal Roof Panel is:
0.01 in.
Please let us know if we can be of further assistance.
Rick_HD_OC
by|Oct 23, 2023
1 found this answer helpful
Q:Why is it a lot higher in Jackson tn than in Covington tn
by|Sep 6, 2023
1 Answer
Answer This Question
A: There could be a local competitor that is lower priced on the product. Stores are 68 miles apart and considered different markets.