Customer Reviews for Fabral 144 in. Galvanized Metal Roof Panel

There are so many different answers to questions and really no definite measurement for a center-to-center joist spacing. Even from the manufacturer that just sends a link to their 2-page information which I used and was off by 5/8 inch on first joist based on their diagram and it multiplied 17 joists down the line. This is a review showing the width from high-rib to high-rib using either a one-rib overlap and a 2-rib overlap. You make your own measurement judgement.

Just what it says, I cut it with a circular saw, just put the blade in backwards, works great.

The roof panels are perfect for the patio.

Easy to install above my deck. Heavy enough to get the job done.

Good roofing sheets. I used them to turn an old swing set I made my daughters into a shade structure for our staycation this summer

Used this product in my fencing project, created a beautiful fence.

I love the galvanized steel skirting that goes along my roof and also around the bottom of my mobile home...

This roofing metal lived up to what I expected it to do. I used half inch screws with the little rubber seal on them.

I used the sheets to build a raised bed for gardening. Sturdy, but easy to cut and drill.

Sturdy, yet still reasonably light-weight. I bought it to give off that industrial vibe for the lobby in our new audio/video recording studio facilities at GIZMO Productions USA, in the Oviedo, FL mall. The shiny galvanized finish is in keeping with new industrial, almost a missile silo kind of look, which we accented with two vapor warning lights. It almost looks like a fallout shelter! We will accent in front of it with a red leather corner sofa, which will look amazing as it reflects off of the sheet metal's shiny finish! I plan on buying more soon!

I rebuilt the framing of a hot tub that was given to my family. In doing so, i had to remove the cedar siding that was on it. Most of it was badly rotted. So i looked for a cheaper alternative to replace and thought of these metal panels. It worked great and we love it. Everyone who comes over comments on it. I highly recommend it.

I had it installed on a Pergola. Love it, easy install!!!

Used this in 3' sections on walls in finished bar area in the basement. A bit challenging to cut and use, however, pleased with results.

Great for bar.

Great I used ot for my ceiling in a salon space

Purchased this product to cover an existing shingle roof on an outbuilding, this product is thin so it needs to be supported. It went up easily laid out straight was the proper length and is performing as advertised. At this point wish I had purchased about 20 more sheets of it as have another project in mind for it.

This roof panel is on the thin side - not as thick as I would have preferred.

The product met all the standards I was expecting. Great to handle and work with.

True to size. Nicely sorted on my delivery of several other items.

This product should never be advertised as suitable for a roof panel since it is so thin! A person can dimple the metal by squeezing between their thumb and index finger. If any small limb or branch which weighed very little were to fall on this so called "roof" panel it would puncture the metal very easily. Buyer beware: DO NOT BUY for use as a roofing panel!

It was been at the end

Check each panel. Otherwise you get different sheets and it will look horrible! They have multiple runs it appears or different batches. Not all the same. Some will look flecked. Some will look satinish. Very frustrating.

The produce is good.