Questions and Answers for Graco Magnum ProX17 Stand Airless 3000 PSI Paint Sprayer

A:  Yes, but you have to purchase a separate kit that contains different gaskets for oil-based products. If you use the sprayer as delivered the lacquer will dissolve gaskets intended for latex paints and will leak, possibly starting a fire.

A:  No, to spray lacquers with the ProX17 or ProX19, you must purchase a lacquer conversion kit, and follow Static Grounding Instructions (Oil-Based materials).

A:  Erik, It depends on the epoxy. I would call us with the specific epoxy information. We can be reached at 844 241 9498 M - F 7:30am to 5:30pm CDT. Thank you, Graco Technical Service Group

A:  No. It uses far too much paint.

A:  Nope.

A:  You have to use the solvent recommended by the manufacturer of the oil based paint, such as mineral spirits.

A:  Randy, The back of the paint will recommend how to clean up the material. If it flammable solvent based material is being sprayed make sure to have the lacquer conversion kit. If it is non-flammable material usually 100% mineral spirits are recommended. Thank you, Graco Technical Service Group

A:  Ben, Typically pump kit 24Y472 would be used to rebuild this sprayer. You would only need to do this if the pump starts leaking or you're getting poor performance. 300 gallons is just a guideline. Graco Technical Service

A:  The pump repair kit is 24Y472. Graco Technical Service

A:  Hello, Yes, you can use the RAC X guard with the Magnum ProX 17. Just remember to lower your pressure with the FFLP tips. Thank you, Graco Technical Service Group

A:  No this unit is only set up to spray with one gun at a time.

A:  Marcus, You can only run one gun on the ProX17 unit. With two guns you would not get the proper spray pattern. Thank you, Graco Technical Service Group

A:  Yes, from what the associate at Home Depot told me, you can run two guns off of the one unit.

A:  Chuck, A lot of roof sealer will be too thick for the Magnum ProX 17. To verify I would suggest getting the product data sheet and calling the Technical Service Group at 844 241 9498 M - F 7:30am to 5:30pm CST. Thank you, Graco Technical Service Group

A:  no

A:  This will do the job. You can adjust pressure and get a new gun tip for fine finish.

A:  Absolutely. This thing sprays super smooth - my wife LOVES the finish it has given our doors, window boxes, and shutters.

A:  This sprayer is sufficient to spray for your job, but you will need to refer to the paint you are spraying for the size and pressure settings to get the finish you want. The machine is more than capable, but there are a few things on the users side that need to be completed as well. Good Luck.