Questions and Answers for smart tiles Murano Stone 10.2 in. W x 9.10 in. Vinyl H Peel and Stick Self-Adhesive Decorative Mosaic Wall Tile Backsplash (12-Pack)

A:  No Mortar needed

A:  Hello. Thank you for your interest in our product Smart Tiles! You do not need mortar for installation of The Smart Tiles, they are peel and stick. While traditional tiles require glue, grout, and specialized tools, Smart Tiles makes it easy and mess-free. Not to mention that it also takes more time to complete a project with traditional tile. The beauty of our product is that it requires little time, no glue, no tools, it is easy to install and can be removed easily without damaging your wall.

A:  Thank you for your interest in our product the Smart Tiles. You can install peel and stick Smart Tiles directly over your existing backsplash, whether it is glass or ceramic and the wall has to be smooth and sleek with no texture. You must also take into consideration the width and depth of your existing grout lines as this might affect the outcome.

A:  Yes, if the backsplash is smooth.

A:  It has to go on a smooth surface. You could always use counter paint to change back splash

A:  Hello there, We have the Smart Edge for sale on our website however this is more for looks then to protect. I would suggest visiting your local hardware store to see what they might suggest to protect the outside corner. Please don`t hesitate to contact us with further questions.

A:  Hello, thank you for your interest in the Smart Tiles. Peel and stick Smart Tiles should not be installed where they may be submerged in water or used as a working surface. It is also inadvisable to put them where they will be in direct contact with steam or flames. So, it is not recommended to install Smart Tiles: in the shower, on the countertop, on the floor, on the ceiling. Despite these constraints, Smart Tiles can be installed in a bathroom, kitchen or on a fireplace mantel. Please don`t hesitate to contact us with further questions

A:  Hello, thank you for showing interest in the Smart Tiles. Our tiles are made of a Gel-O technologie that gives a 3D look to our tiles. Please don't hesitate to contact us with further questions.

A:  Hello, thanks for your question and interest in Smart Tiles. Especially designed for a kitchen environment, Smart Tiles are highly resistant to the heat of a stove. However, it is highly recommended to prevent direct contact with open flame. If you install Smart Tiles behind a gas range without a protective rear panel, allow a height of 15 inches above the surface without Smart Tiles. Please do not hesitate to contact us with any questions.

A:  Hello, thank you for reaching out. The Smart Edges are now available at Home Depot.

A:  Hello, thanks for your question and interest in peel and stick Smart Tiles. Begin from left to right. You will need to cut the tabs on the first tile, turn it up side down, and connect the next tile. This way you will be able to overlap on grout side. On your 4th sheet, just cut the excess. The Smart Tiles are really easy to cut and maintain. You just need a box cutter. Also, be sure to overlap the “grout” lines so no one will notice the seams. Please don’t hesitate to contact us with any questions.

A:  8ft x 8ft = 64 sq feet 12 tiles = 6 sq ft 64 divided by 6 = 10.6 [boxes of 12] always buy extra

A:  Hello, thanks for your question and interest in Smart Tiles. If you need to cover a 8 ft x 8 ft surface, you need exactly 110 tiles of Murano Stone. Please don’t hesitate to contact Smart Tiles with any question: 1-877-784-2733.

A:  Each 12 pack covers 6 square feet. For 8' x 8', or 64 square feet, you would need a minimum of 11 packs.

A:  The Smart Tiles are so lightweight and thin (1/16”) that you can install directly over existing tiles. For the preparation, make sure the wall is smooth and clean before you install the tiles. The tiles are easy to remove with a blow dryer if you warm up each peel and stick tile long enough to soften the adhesive and pull softly starting with the corners

A:  Hello, thanks for your question and interest in Smart Tiles for the peel and stick backsplash. The Smart Tiles are so lightweight and thin (1/16”) that you can install directly over existing tiles. For the preparation, make sure the wall is smooth and clean before you install the tiles. The tiles are easy to remove with a blow dryer if you warm up each peel and stick tile long enough to soften the adhesive and pull softly starting with the corners. Please do not hesitate to contact us with any questions.