Questions and Answers for smart tiles Murano Stone 10.2 in. W x 9.10 in. Vinyl H Peel and Stick Self-Adhesive Decorative Mosaic Wall Tile Backsplash (12-Pack)

A:  Hello Beth, our peel and stick tiles are resistant to moisture and humidity and can be installed in the bathroom over the sink as a backsplash or over the shower where there is no direct contact with the water.

A:  Hello, Thank you for your interest in the Murano Stone tiles. Unfortunately, this model has been discontinued and is no longer available.

A:  Hello Silvia, thank you for your question. The surface would need to be smooth and sleek. We do not recommend installing Smart Tiles over natural plywood. The plywood should be covered with primer or paint before installation.

A:  Hello, thank you for your question. Absolutely, you can install peel and stick Smart Tiles directly over glass provided that your surface is smooth, sleek and without texture.

A:  Hello, Thank you for your interest in Smart Tiles. Smart should only be installed on smooth surfaces that are without texture. They are very thin (.07in) and flexible and if there is an uneven surface the imperfections could be apparent. If you would like fill the hole, sand and apply primer, the tiles could then be installed on the surface.

A:  Hi Jiva, please follow the link to the Homedepot.com Bathroom Installation Services page which I have linked below to begin finding information about installation availability in your area for this particular inquiry and project. We appreciate your business and look forward to serving you in the future. Thank you for shopping Home Depot! http://www.homedepot.com/c/IS_Bathroom_Installation

A:  No it must have a smooth surface

A:  Smart Tiles can be installed directly over your existing backsplash, whether it is glass or ceramic provided that your surface is smooth, sleek and without texture. You must also take into consideration the width and depth of your existing grout lines as this might affect the outcome. We recommend discussing installation with a customer care associate.

A:  Yes it can... just wipe down existing tile before hand

A:  I don’t know what Zinssers Gardz is but I applied over painted drywall with no issues

A:  I applied directly over flat wall paint. No problems and excellent bond.

A:  Hello, Thank you for your interest in Smart Tiles. We do not recommend installing over Zinsser products because it has a chemical component that affects the tile from adhering well to the surface. Thank you.

A:  If you have a good finish on the wall will a little patience you should be able to get it off. But be aware you might have to do minor repair.

A:  You may have to paint after. I applied the tiles and repositioned several times. However, after they were in place for more than an hour, the paint was peeling off when I tried to reposition them.

A:  Hello, Thank you for your questions. Smart Tiles should be installed on a wall that is smooth, sleek and without texture. You might need to sans down to make a smooth surface, it is also important to have at least one coat of paint primer that has been cured for 72 hours before installing Smart Tiles. They are easy to remove with little to no damage, depending on the surface they were installed on. To make it easy, use a blow dryer to warm up each tile to soften the adhesive and pull softly starting with the corners. Use a cleaning product to wash the wall and remove any excess glue left by the Smart Tiles. You might need to paint the wall after removing them. Melanie -Customer Service