Customer Reviews for M-D Building Products 1/2 in. x 3/4 in. x 10 ft. Gray Foam Window Seal for Ex-Large Gaps

It's a little thick for my door but it is a good product. My fault for not measuring haha. Thanks guys.

The tape works fine as a fix for sealing the bottoms of screen and storm doors. I do not know how long the adhesive will last. Time will tell.

Doesn't compress as easily as some products like it.

it didn't stick its junk

Rating provided by a verified purchaser

Rating provided by a verified purchaser

Here's how you use this product the way they designed it: take it out of the package and throw it in the trash. The foam is nice, but it doesn't stick to anything for more than 15 seconds and if you close a door or window on it to help it adhere, the foam will get stuck on the door/window instead of the frame (and no, I didn't install it backwards). Complete garbage product.

Rating provided by a verified purchaser

I used this tape to replace the failed seal on a commercial freezer. The adhesive stuck fairly well once I figured out which side of the foam has the adhesive. Of course I did clean and dry the surface that I was sticking it to. The tape worked very well, but it is not "stupid proof", and so a kitchen hand was able to rip it off while cleaning the door. This tape will not stick to surfaces covered with soapy water! So while it is a good product it is not "stupid proof". What can I say? You Can't Fix Stupid! The product is good and works well, though, and saved a whole lot of frozen food. Not quite the intended use, but it certainly is good stuff. I will certainly use it again when I need a good seal.

Rating provided by a verified purchaser

Rolls don’t contain 10’ of useable foam. The last 6” is ruined by the cardboard roll. After installation the foam immediately fell off.

Good stuff and last for a long time

Rating provided by a verified purchaser

The foam is only 3/8" thick (not the labelled 1/2"). Do not buy this if you truly need 1/2" of foam, like I did.

1/2" is more like 3/8" - I needed the whole 1/2" - so i still have a gap for mosquitos to get into the house

The self adhesive on this product was so poor that it couldn't support the weight of itself when mounted horizontal. It would stick for a half minute then peal itself off.

This stuff is absolute garage simply because the self adhesive is very weak and won't stick to anything. (and yes I had a perfectly clean metal surface)

Did the job I needed well. Adhesive stuck good. Some backing was hard to remove. Supposed to be 120 inches but the last 4" are unusable as they are permanently stuck to the cardboard core.

Works well on sealing large spaces. High density makes for a tight seal.

Few choices in this dept I have yet to resort to hot glueing this stuff in place - for now - I simply replace it once it no longer holds...

I have found that all foam weather srtips are difficult to work with, not removeable once you stick it down, it stays or you damage the strip to remove it, and it just doesn't last its easily damaged from just opening and closing the door or window and you have to replace it to soon.

I found on md brands that the adhesive bonded the sticky backing so that it can not be removed without damaging the weatherstrip prior to application. I found I could use a heat gun to soften the adhesive enougth to remove it an then apply the strip - more sticky was on the white paper then then actual strip. A real pain to use. The air temp was 70 degree. I would not buy this brand again.