Customer Reviews for Oatey 16 oz. Dark Thread Cutting Oil

It took the heat off of the dies very well,Also lasted for a while while threatening

The cutting oil work great make the threading easy and clean

Rating provided by a verified purchaser

Good for both cutting and drilling

Worked great the thread is super smooth and the bit didn’t break off inside so 10/10 for me.

I use this with the chainsaw sharpener I have that has a crank on it. I can tell that with this oil it cuts smoother and takes out the shavings.

Worked exactly as expected

Good cling. I use it for thread cutting on aluminum so not a rigorous application but it has good lubricity

Got a full bottle of cutting oil. last one on the shelf!

This oil did a very good job keeping the heat level down while I cut a very long piece of quarter inch thick steel. Also prevented the blade from wearing out I highly recommend this product.

It helps drilling the broken bolts out some what easier.

Make drilling through harden steel a lot easier, keeps chips stuck to the drill bit for easy removal. Drill bit made a lot of holes without dulling. big bottle for what I needed it for.

This stuff worked great on a project I recently did. I applied this stuff to a hole saw that was used to cut several holes in an exhaust pipe. Following the second cut, the teeth still held a sharp edge.

I have used it before and always go back for the same product. Helps the taps and dies stay sharp.

After cross threading. I was chasing a M12 bolt thread. This made it very easy with the thread tap. Without this fluid on my test attempt I was about to break the tap.

Rating provided by a verified purchaser

Made drilling through steel easy!

Rating provided by a verified purchaser

Needed a thread oil that would hold up to hand threading and it did a great job and project is finished