Customer Reviews for TrafficMaster Carrara Marble 4 MIL x 12 in. W x 12 in. L Peel and Stick Water Resistant Vinyl Tile Flooring (30 sqft/case)

Very easy to install but you need to be careful that they don't touch before you have them where you want them to go. They REALLY stick. Not sure about the reviews that say these don't stick because if mine touched the floor before I had it set, I had a hard time getting it to come back up. I used spacers and grout to give it a more "real" look and you can't tell it's not. Love it!! Tile are also quite sturdy but be sure to get grout that is specifically made for vinyl floors.

Very easy to install but you need to be careful that they don't touch before you have them where you want them to go. They REALLY stick. Not sure about the reviews that say these don't stick because if mine touched the floor before I had it set, I had a hard time getting it to come back up. I used spacers and grout to give it a more "real" look and you can't tell it's not. Love it!! Tile are also quite sturdy but be sure to get grout that is specifically made for vinyl floors.

This tile is great for a relatively speedy, inexpensive and beautiful DIY. First time ever laying any tile, and had no major issues. I removed the old linoleum first as it was in pretty rough shape. I sprayed each tile with Gorilla Glue spray adhesive before laying on the subfloor. I used a premix grout and the result looks like real marble/stone. Dawn Powerwash removed the grout haze 100%.

These peel and stick tiles are being used in a laundry room. They almost look like real porcelain tile

Easy to Install. However the quality control is poor. I purchased two cases, 60 square feet of tile to do a 35 square foot kitchen. I would say that 30-40% of the tiles had some blemish and about 20% where unusable. It's too bad that companies do not have pride in their products to allow a release of so many tiles that were not good. That being said the floor looks good and for the price I guess you get what you pay for.

We have had this flooring installed for 5-6 months. Any dirt that gets on this floor stays with it. We replaced a few after about 2 months and the color change was shocking. We have used multiple cleaners to try and get the dirt off and had no luck. I wouldn’t use this in any entryways and high traffic areas if I ever purchased it again.

I replaced my powder room with this flooring and it looked beautiful. However, it did not take that long where dirty looking spots will NOT go away no what product I use to clean it!!! I AM VERY UPSET AND DISAPPOINTED!!

Easy to install, and the look (even without grout) is stellar. Time will tell if it holds up, but I am pleased with the product thus far.

Easy installation and look great.

Did a bathroom. Great results, especially for a beginner. The tiles cut easily with a scissors, or you can score and break them with a utility knife. Very nice product, BUT, don't trust the arrows on the backing paper for pattern orientation, a few were wrong and I had to spin the tiles to align the pattern.

We installed this in our house, I bought 39 cases to do the first floor, luckly we stopped at the 20th case, the floor started to look gray, ugly and very dirty only on the 2nd day, now has been 2 weeks and there is no way I am finishing the house with this tile, nothing cleans it,We already have several stains on the floor. It looks beautiful for a few weeks, I like the idea of having the marble look on it but it gets dirty very easily. Would not recommend it, I am returning the other 19 cases to home depot and buying different flooring, once the floor gets dirty its almost impossible to clean it, we used all kinds of cleaners and nothing does the job, dirt settles in them very well. Save your money and buy better quality flooring, buying this vinyl it will end up on the waste-fields and harm the environment in a few months. I am hoping that TrafficMaster will step in and give me some of that money back so that I can at least say that they do take care of their customers very proffessional. we wasted 19 cases of product and lots of labor. This is very disappointing. Thanks for reading.

Used this with another brand tile for my wine room. I wanted the marble and wood combo without the hefty price.

I love it, it was my DIY project, it was harder to prepare for installation then installing it, i removed my existing tile that was already installed over old linoleum, I've kept linoleum as my waterproof layer, however: i would recommend layout the whole tile design first separately, and once satisfied with the overall pattern flow /design, then goahead to install it. Easy to cut, adhesive is strong, inspect tiles before installing from scabs on the edges, you can sand it off edges if needed.

I love it, it was my DIY project, it was harder to prepare for installation then installing it, i removed my existing tile that was already installed over old linoleum, I've kept linoleum as my waterproof layer, however: i would recommend layout the whole tile design first separately, and once satisfied with the overall pattern flow /design, then goahead to install it. Easy to cut, adhesive is strong, inspect tiles before installing from scabs on the edges, you can sand it off edges if needed.

This came out great!! I thought it was easy to cut and really sticky. I didn’t use extra glue. I also grouted. I am a very novice level diyer.

So much better quality than previous tile I had installed. Really makes a difference !

I read all the the reviews on these “easy” to lay tiles. The laying is easier. However, you have to cut them perfect. One tile wide than the other and you’re off. I chose to do my tiles in the herringbone pattern. It was a lot harder than the 12x12 squares but so worth the time and effort. I did get the premixed grout in charcoal. It’s nice, no need to seal it after. I had some areas that showed grout stain on the tile. Removed that with nail polish remover and it’s perfect!

Like some of the other reviewers I ended up cutting the 12x12" blocks into 3rds. One way to speed up that process is to break down the box the tile comes in and mark it with where the tile needs to be cut, then use a straight edge so you're not having to measure for each piece. When cutting you don't have to press down hard at all (unlike with drywall), just run a utility knife along the line you want to cut then snap. Lighter pressure makes it easier to get straight lines.

Installation was easy and fairly quick, just need a razor blade to score and cut. The difficult part was grouting… We first used a grey grout and found that after using a sponge to clean off the excess caused the grey color to seep into the pores of the tile and making it impossible to clean off. We scrubbed for hours with no luck using vinegar and ammonia. Luckily I had some white grout left over from another project and I started using it. The haze blended in with the tile making it somewhat unnoticeable. I then topped it off with a high traffic floor finish. The end results look good but we will see how long it will last

So easy to install and turned out better than I could have imagined. We wanted to reface our fireplace tile that had pink tile, we stuck these right over the old tile and are so happy with the results

I'm remodeling an older style farmhouse and since there's so much to do I needed things on a budget. There were a few bad pieces in each box, but I saved those for side pieces that needed to be cut. I cut each tile into 12" by 4" strips and laid them out in a herringbone pattern and grouted in between. They stuck down nicely (especially after grouting) and they didn't show any damage or haziness from the grout. Thanks everyone for putting up their pictures, it worked out fantastic!

Installed on top of existing tile. The adhesive is strong and didn’t shift as long as it was on an even surface. The paper backing wasn’t a problem to remove. If grouting it recommended using larger spacers but I used smaller ones and they worked just fine. I used Skill Set premixed vinyl tile grout. I didn’t know if the grout would actually work since the depth is shallow but it turned out great and haven’t had any problems. I wish the design had less veins but still nice for a mini facelift!

I cut this tile into 4 inch strips and made herribone pattern and it turned out beautifully

Easy to cut and install. Doesn’t seem like it’s well stuck at first, but if you press hard, give it a day and then grout, they stick great with no extra adhesive. We cut in 4 inch strips and laid in herringbone pattern and looks awesome after looking at peoples review photos. We’ll see how they hold up, but for the price and a quick fix we are very happy. We put this directly on an old cracked hex tile. No pre other than cleaning. Floor def wasn’t fully level. Final product isn’t perfect but for a days worth of work and like $80 or less including tools it made our horrible damaged floor so much better u til we get around to a full Reno. Wish I did this years ago!

I don't suggest buying this for the purpose I did as I'm certain it will void the warranty. Extremely impressed with the durability of this tile. Can't believe you can grout it. Easy to work with. Lifetime warranty for residential use. I used this tile on a ceiling but love it so much I will be buying another pattern to actually use as a floor. I have no doubt even though I did not install for it's intended purpose it will hold up because that's how well it's made.

After reading all of the reviews even the bad ones I was willing to try these. I accidentally hit a sale and got them for 99 cents per square foot. I would recommend getting an extra box just in case. I did the flooring by myself and this was my first time putting flooring down. I prob took longer as I staggered them and alternated the way I laid the pattern. A vinyl tile cutter saved me and made it much faster and easier to make awkward sizes needed for my crooked old house.

Recommend using spacers and grout. It looks really nice. Must wipe the grout quickly as you go, as it’s impossible to remove from the tile surface if dried. Affordable option — we used just over one box for a small bathroom.

I cut these tile down to a 4x12 and did a herringbone pattern in our bathroom, used a slate gray vinyl tile grout and they look amazing! Easy to work with and way better for our old farmhouse then try to use regular tile.

Very good product, install them in my floors they look great, and are durable.

I had a peel and stick tile down for about 12 years and wanted something different so I took the old tiles up(very sticky, they were on there good) and put these new ones down in a herringbone pattern. Hopefully these last as long as the old ones. I do recommend using a paper cutter to cut the tiles. Luckily I had one which made cutting them so much easier and faster than cutting by hand.