Trim Board Primed Finger-Joint (Common: 1 in. x 6 in. x 8 ft.; Actual: .719 in. x 5.5 in. x 96 in.)

as with any wood outside, it has to be maintained. I wouldn't be afraid to use it if I know I will take care of it down the road

I've used this product for exterior window trim on many jobs and if you apply a couple of coats of high-quality exterior paint it wears very well.

Either paint or solid color stain. Mike

Since it is primed it won't absorb stain, it does take paint very well.

I have used these boards many times and they have always been straight and the dimensions are consistent.

I have used these on three different occasions over the past 8 months. They will make the job much easier and save you a lot of time . It is of very good quality and I was pleased with the results.

Should work fine as a widow sill. I would only use it in an interior location.

If you install it properly and top coat with high quality exterior paint it will do very well.

This will work best if the board you're replacing is interior and does not get exposed to water. As this board is finger jointed and made of glued pieces together, it would not work well in a situation where it gets exposed to water (such as outdoors). If its going to be a wet installation, I would not recommend finger jointed boards.

Interior yes

NO ! ! ! Poor quality and under size

Yes it will work if you are talking about on the face of the garage like a picture frame. But if you are talking about the trim that actually touches the garage door to create a tight seal then I would advise against it. The wood the is used at that location is usually pressure treated 2x material. The reason is that the very bottom of the board sits on the ground and will likley be exposed to water and moisture can easily become trapped behind the board. Over the years the bottom of the board can rot and attract insects etc. The likelihood of this happening in a shorter period of time if you use a thinner , nonstructural grade lumber that also is not pressure treated or rated for ground contact.

sure you can do that.

I would only use it for interior projects

Can I use this board on the ceiling like a small beam?

Nails, screws or construction adhesive, they'll all work.

yes, we used nails to install ours

Yes or screws

Yes you can use nails.

Can I use this board on the ceiling like a small ceiling beam?

I wouldn't recommend it as finger joints are glued - might separate with outside exposure

I would only use this type of board for interior projects.

Yes it will work for that, just make sure it is the correct thickness for what is being replaced, of course it can also be double layered as well.

Yes, however I would use a thicker wood to avoid warping. Most homes have 2 x 6 Douglas Fir or Southern Yellow Pine as fascia boards. Mike

No

If properly painted.

I don't think waterproof - finger joints are glued - might separate with outside exposure. You would need to seal well. Instead, why don't you use one of the PVC alternatives?

Hi this is not water proof, how ever it is water resistant and can be used for exterior home use.

No, this is not waterproof.