Return this item within 90 days of purchase.
Get an answer now with AI
Magic Apron Assistant is an AI virtual assistant. By proceeding, you consent to the recording and use of your information by The Home Depot (and authorized third parties). More information
Cut perfect 2-1/2 in. circles into a variety of abrasive materials with this Carbide Grit Hole Saw from Milwaukee. Constructed with a tungsten carbide grit edge, it saws holes into tile, fiberglass, brick, cement board and block to produce round cutouts commonly needed for plumbing or electrical conduits. A carbide-tipped pilot drill bit is included to keep cuts straight and centered.
Bit Diameter | 2-1/2 in |
|---|---|
Bit Length (in.) | 1 in |
Drilling Depth (in) | 1.8 |
Hole Saw Diameter (in) | 2-1/2" |
Shank Diameter | 3/8 in |
Arbor included | No |
|---|---|
Arbor Size | 1/4 in |
Bit Material | High Speed Steel |
Drill Bit Type | Hole Saw |
Drill Bit Type(s) Included | Hole Saw |
Included | Pilot Bit |
Individual/Set | Individual |
Material Application | Brick, Ceramic Tile, Fiberglass, Plaster |
Min Chuck Size Required | 1/2 In. |
Returnable | 90-Day |
Shank Style | Hex |
Teeth Per Inch | 3 |
Tools Product Type | Power Tool |
Yes, this is designed for abrasive materials.
Hi, Keith. Yes, the Milwaukee 1-1/4" Carbide Grit Hole Saw is designed to drill through tile. It features a tungsten carbide grit edge specifically for cutting abrasive materials such as tile, brick, and cement board. For optimal performance, it is recommended to use a carbide-tipped pilot bit when cutting ceramic tile.
Stucco can be plaster/cement blend. It should be no more of a burden than drilling cement board as long as it is not thicker than the depth of the “cup”. If you only need a a few holes this should hold up fine.
The Milwaukee® Carbide Grit hole saws are designed for cutting abrasive materials such as brick, block, cement board, fiberglass and tile. - Milwaukee Tool, Social Team
Hammer drill works better and faster.
Hammer is not recommended for hole saws with carbide teeth or diamond/carbide grit cutting edge in ABRASIVE materials. Hammer dislodges the grit quickly. You can drill a few holes faster in hammer mode but you will quickly render the tool useless.
Not sure if recommended but I did not use a hammer drill and it worked great on brick. The only problem was my mandrel was too big to let the saw go deep enough fyi for anyone needing to go for a deep hole measure the mandrel before buying.
Yes, drilled two holes with no problem.
Wont last long. You need the diamond coring bits. This is mostly for stucco and soft brick/block
You bet it will and a lot faster than you would think.
No. It will burn out. It is for stucco and light brick or pavers
Yes, I believe it will cut but depth limitation may be a problem for 2 layers of brick.
Yes, this should work, you may have to chip away the thickness gradually
FRP is also term for Fiberglas Reinforced Plastic. Chopped Fiberglas strands are added to plastic molding pellets prior to injection molding. This composite resists cracking from high impacts. Also coefficient of expansion is reduced.
yes
Yes, the bit does cut through FRP.
Don't see why not. Cuts through stucco easily. I would think a standard hole saw would also work on FRP, which is just fiberglass I believe.
If FRP is fiberglass reinforced pipe, it should with no problem.
Viewing 1-8 of 23
4 out of 5