Christy's Red Hot Blue Glue 8 fl. oz. PVC Pipe Cement is ideal for situations needing quick or immediate pressurization. It gap-filling capabilities make it a good choice for working in most types of weather conditions to seal pressure and non-pressure, potable and non-potable PVC pipes. Size of 8 fl. oz.
PVC solvent cement that works in most of weather conditions, wet or dry
Fast, quick set that is ideal for situations requiring quick or immediate pressurization
Medium-bodied formulation that provides excellent gap-filling capability and a bond for life
Low VOC formulation that is environmentally friendly
For use on pressure and non-pressure, potable and non-potable PVC pipe through 6 in., interference fit
Can has applicator in lid for ease of use
Meets ASTM D-2564 standards and is NSF 14/61 listed
Q:how many 3 inch joints will one can do? I've a 60 ft run plus connections. It's bout a 3 hr drive for supplies & I hate to waste half a can.
Thank you in advance
by|May 28, 2023
1 Answer
Answer This Question
A:Â The 16oz can should be sufficient -- but depends on the number and type of connections. This sized can will solvent weld 8-10 connections (elbows and couplings.) A few less if you're using wyes and/or tees.
by|May 31, 2023
Q:Is this glue good for PEX?
by|May 18, 2023
1 Answer
Answer This Question
A:Â No. This product is for PVC pipe/fittings.
by|May 24, 2023
Q:What's the lowest outdoor temperature I can use this glue?
by|Dec 24, 2022
1 Answer
Answer This Question
A:Â -25 degrees F
by|Dec 26, 2022
Q:can this be applied under water? I have some submerged pvc and have to glue it in place.
by|Sep 3, 2022
0 Answer
Answer This Question
Showing 1-4 of 24
Customer Reviews
4.7 out of 5
(737)
4.7
out of 737 reviews
89% recommend this product
5605
485
311
213
123
Filter by:
Showing 1-10 of 737 reviews
Jul 15, 2020
Excelent product
Excelent product
by
Verified Purchase
Recommended
1 found this review helpful
Jul 14, 2020
Like this product it's easy to apply and quick on sealing
Like this product it's easy to apply and quick on sealing
by
Verified Purchase
Recommended
1 found this review helpful
Apr 26, 2020
So simple and easy to use no primer required always holds great! Only pvc glue I buy.
So simple and easy to use no primer required always holds great! Only pvc glue I buy.
by
Verified Purchase
Recommended
1 found this review helpful
May 9, 2019
I will probably not buy this product again. I have installed systems with the clear cement and w...
I will probably not buy this product again. I have installed systems with the clear cement and with this. It's not that it leaks. BUT:
*It drips -- a LOT
*Unlike the clear cement, the drips are dark blue. This cement leaves unsightly marks on my work wherever it drips
*I like my valves and joints to line up perfectly, and when doing more than one joint at a time, this cement often sets before I have time to align all my parts perfectly
*It is so thick that it piles up inside the pipes. I use the recommended primer and the applicators in the cans. When I look down the pipe at the inside of my joint and I can see buildup where the cement has been 'plowed' up by the pipe as it slides into the fitting. Seems like this would impede flow....that is, until the chunk of cured cement breaks off and moves down tube to clog a valve or spray nozzle
by
Aug 4, 2016
This stuff is great!
We bought a house that has a little bit of age (just after WWII built). The lawn sprinklers were old and fatigued and were easy to break if digging to close. The PVC pipe that is installed is the old blue thin wall type which I do not think is made anymore. Long story short, when I would dig a hole and the PVC pipe would break, I would gather my PVC repair tools, which included this glue to make the repairs. The glue is fast drying, easy to apply and seals joints as if they were melted together. In general practice, I would cut bad pipe, sand ends about an inch, then apply the glue and connect the new part to the old part. I would hold the part in place for about 30 seconds and lightly give it a twist to check the bond. After about 5 to 10 minutes, I would turn on the sprinkler valve to check for leaks. So far, I have been very lucky not to have any leaks occur after a repair. At the time of this post, this would be my 6th repair with the sprinkler PVC pipe using this blue glue. And I can say honestly, the glue works. Read the instructions, go to youtube, watch a video. If this glue is applied correctly, then it will work. I bought another can of blue glue because I know this will not be the last time I will need to repair the sprinkler system. Sincerely, an honest homeowner.
by
DIY
Recommended
7 found this review helpful
Jun 2, 2023
by
Verified Purchase
Jun 1, 2023
by
Verified Purchase
May 27, 2023
I went into Home Depot not sure of what I...
I went into Home Depot not sure of what I needed. I left home in a hurry and I didn't take a picture of the issue I was having. When I got to the store, I explained to the representative the problem I was having, and he was able to draw me a picture explaining how to fix it.