The Kreg rip-cut turns your circular saw into a precision edge-guided cutting tool that makes straight, accurate, repeatable cuts in plywood, MDF and other large sheets. With the rip-cut, you can cut with the confidence you want and the precision you need. The rip-cut easily makes straight, accurate, repeatable cuts without measuring, marking or having to keep the saw on the cut line. The rip-cut does this with a long edge guide that follows the straight edge of the sheet you are cutting. So, all you have to do is lock the saw in at the measurement you want up to 24 in. using the built-in measuring scale and then make your cut. With a built-in measuring scale, you don't have to measure and mark each cut, either. Just lock the saw sled at your desired cut width and you're all set, whether you need to cut 1-piece or make multiple pieces of the exact same size. Plus, the rip-cut makes it easier to cut down large sheets by yourself. The rip-cut is very easy to use. Simply mount your saw to the universal sled it accepts most left-blade or right-blade saw-sand then slide the sled onto the aluminum rail. After a simple 1-time calibration, you can lock in your cut width (up to 24 in.) using the measuring scale and precision cursor. Then, just hold the edge guide against the edge of your sheet as you guide the saw. You will get straight, accurate, repeatable cuts easily every time.
- Straight, accurate, repeatable rip cuts and crosscuts made easy
- Make rip cuts and crosscuts up to 24 in. W
- Cut multiple pieces to the same size with just 1-setup
- Use the oversize edge guide for precise control throughout the cut
- Eliminate need for marking, measuring and layout lines
- Take your saw to the material instead of having to take your material to the saw
- Universal sled accepts most circular saw left or right blade
- Reversible edge guide for left- or right-handed use
- California residents see Prop 65 WARNINGS
