if you read the product info it says it will cut up to 20 gauge materals. now i have used it to cut metals that were a little thicker like 18g sheet metal and it worked just fine just had to cut it a little slower. now as far as rebar unless you have the worlds smallest rebar and its 20 gauge or thinner its not going to cut it.
Please feel free to call Malco Products Customer Service at 800-328-3530 with any questions or concerns you may have about this product.
Please feel free to call Malco Products Customer Service at 800-328-3530 with any questions or concerns you may have about this product.
Although it can cut through heavy 20-gauge galvanized steel, the TS1S it is not recommended for cutting corrugated metal. Home Depot does offer the Malco TSCM that is recommended for cutting corrugated metal roofing material.
No, there is no lifetime warranty on this product.
No, drill requirements are 1/4 in. (6.35 mm) chuck, min. 14.4V-DC, Max 7A-AC
We used it on roofing metal.
Yes on the package.
No, you can not cut laminated shingles.
No, it would not cut hardie board. It can not cut anything thicker than about 20 ga metal.