Stainless Steel Scratch Eraser Kit

Do NOT use this product. Still have the scratches and now it looks like this.

Had a small scuff on a brand new stainless stove and the kit worked flawlessly! Was very nervous reading other reviews, but turned out great. Glad we tried it.

Basically, used product as instructed and it caused hazy, ugly scratches to cover up the initial scratches. In retrospect the scratches this product caused look worse then the initial scratches from every angle. It will NOT make your refrigerator doors look restored or new! it didn't help and made it look worse.

I recently found myself wanting to sell my garage refrigerator. Being a 10 year old unit in a garage, it picked up a few scuffs and scratches along the way. I figured this kit was cheap, and might yield $50 more dollars when I sold it, by removing some scratches on the doors. This product DOES work, but it's VERY difficult to do it right. The problem is that it requires you to wet-sand your stainless steel in the same direction as the grain of your steel. If you're even off by a few degrees, or if you can't move your hand in a perfectly straight line hundreds of times, you will be able to notice the "repair." From some angles, it looks good, but from others, it stands out like crazy. I've attached before and after photos of a "good" angle. At the end of the day, it's almost better to just leave the scratches, unless you do what I did. I bought hand sanding pads from the paint section, which are exactly what this kit includes, but they are full size. I also bought the handle that attaches to the pads to give me better and more consistent control of the pad. I wet sanded the ENTIRE refrigerator door, using any off-the-shelf stainless steel spray polish as lubricant. If you refinish the entire door, there isn't one spot for your eyes to get drawn to. With the larger pad and handle, you have a much easier time making straight lines. In total, it cost me $15 and 30 minutes of work.

I saw a review on here that showed a photo of the product having been used on a Samsung refrigerator and it looked like the scratch repair was perfect. Now I don’t believe that that was a true photo. Having a Samsung refrigerator, I tried this product, but shouldn’t have because I did not check to see if my appliance is coated. I followed the directions, expecting the result to be as shown in the picture left by another reviewer and got awful results. That’s when I found out that the Samsung refrigerator is a coated stainless steel.....so, my fault. I should have left it alone....it looked better before I tried to fix it. I’ve attached pictures of the results.

Good for one small job. It’s a small kit for a single small resurfacing. The kit does not come with anything to remove deeper scratches which require mid-grit sandpaper and/or steel wool, and there’s just a small envelope of the cutting lubricant, so it’s really just for re-surfacing something a bit worn rather than any serious scratch removal. The handled scrubber is skinny so the pads are small and don’t last long. It scrubs vertically ok but is difficult to keep from rocking when holding it horizontally to cover a larger area. The cutting lubricant works well to blend the new scratches. I was not able to get the deep scratches out of my sink, but it did polish it and add a little brushed grain back. The instructions and kit are good for a novice. For any serious work, you will need more than this.

Bought to clean up a sink in a recently purchased house- loved the results

Rejuvenate stainless steel scratch eraser worked very well on my brand new oven door which was scratched during installation. However, the packet of solution is inadequate. The manufacturer should include more solution in a bottle. I finished the job with a spray bottle of water.

This product worked exactly as described. The results exceeded my expectations! I was afraid to use it based on some negative reviews. I bought a used stainless fridge that had mostly swirl marks from previous owner cleaning and a few other minor scratches. I started out with lighter abrasive pads and only worked up as necessary. It took time. The trick is to proceed with moderate pressure and even strokes with the grain and blend with the adjacent area. When I ran out of the lube (come on guys, provide more product) I used Bar Keepers friend liquid spray. Finish by wiping the entire area repeatedly with the micro cloth. I then finished off with Windex and paper towels. FANTASTIC RESULTS! Would have given 5 except they're chinzy with the lube. I hope you can see the difference in the photos. The photos don't really do it justice.

Just purchased this product to fix minor scratches on my stainless steel stove, followed the directions perfectly and watched a few videos before use of the product to make sure i was doing it correctly. This product is not intended for a single scratched up area of stainless steel, made the scratched area look even worse. Instead of a few minor scratches that was only seen in cretin lightnings and angles now i have a patch of scratched up area that's visible at all times and at all angles and made my stainless stove look horrid. Do not use this product if u just have a small area to fix, you will need to redo the whole area of the stove and the packaging does not provide enough of the oil to do the whole thing. my now $1000 stove looks like an uncared for. I would not recommend this product at all.