20V MAX XR Cordless Brushless 1/2 in. High Torque Impact Wrench with Hog Ring Anvil and (2) 20V 5.0Ah Batteries

I have not submerged mine under water, but seems to be ok in the rain and damp conditions .

If you're defining getting it wet buy submersion it underwater I would highly recommend not to do that, if you get a little bit of rain on it and you can blow dry it and let it dry before you work it okay but don't stick it underneath the water and try and use it that's common sense, but if you left it out in the rain and it gets soaked blow dry with hot dryer and spray with wd40 the electric parts lightly and should be good to go

Only use it in dry weather conditions to be safe.

We would not recommend exposing the DCF899HB to wet conditions. Ticket #3003798

It depends on how wet. If it is under light rain to remove a tire or something and you don't let it soak too much it will be fine but remember that this is an electric tool with open ventilation ports so just try to avoid wetness at much as possible

Hi. The DCF899HB is currently on factory back order with no eta at this time.

No problems

Had mines ordered to the store and it arrived early

Si lo es

Yes, it states above: "Power Tool Features: Brushless, LED Light"

I don't know it it is brushless or not but it is a Bad Mo Fo! Extremely good power and batteries last a long time. Takes the lug nuts loose and retightens to Torque spec or better on my horse trailer with 10000 pound axles..Drove dozens of 3/8 by 8" lag bolts into treated 8" X 22" beams with no problem. Great tool. Have air and electric impacts as well but really enjoy the cordless feature.

Yes, that battery is compatible with this tool.

Hello yes the 6.0Ah would work on the model.

Yes it is very compatible. It has fantastic capacity to run the impact wrench. It is highly recomended.

Yes all the 20/60V 6.0 Ah batteries work on the 20V tools I have a 6.0 Ah battery on my 899 it lasts forever

Yes it is. I have that same battery and use it with this impact wrench.

Instead of a little ball locking the socket in place this tool has a little ring kinda like a snap ring that locks the socket so you don’t have to use a small screwdriver to realese the socket when the ball gets worn.

A "Hog Ring " is a method of securing a socket to the anvil (output shaft where you place a socket, i.e.- 1/2" anvil). It is a slightly compressible ring at the end that allows a socket to slip over, with some slight effort. The ring will keep the socket secure to the shaft, even if you point the gun downward. The other option is the "Detent Pin". This pin aligns with the hole in a socket to keep it on the anvil shaft. The pin needs to be manually pressed (usually with a small screwdriver or pick) to remove the socket. This may be preferable when there is minimal need to change the socket.

Parts are made in China product is assembled in United States

Yes, this is model is built in the USA. DEWALT is now offering a selection of different power tool, hand tool, and accessory products that are being built right here in the USA, using materials and components from all over the world.

Mine was USA

Parts are made in China yes but the product itself is assembled in the United States O

China

Yes

Yes, you can use any DEWALT 20v battery regardless of amp hour.

Yes

Yes but it wont last very long at all and it wont have full power.

Yes, but it won't last very long.

Yes

What is the question?

No