A: Thanks for asking, Wade! The Radiata pine product provides a clean, stable and warp free finish when installed correctly. It has been recommended to use either construction adhesive liquid nails or Brad nails, whichever you feel works best for your project.
A: I would not install over a popcorn textured ceiling. This product needs a flat surface to install over. On a ceiling, adhesive would not be enough to hold the planks. No, it cannot be blind nailed. I installed with an 18ga brad nailer and applied putty on the nail holes prior to painting.
A: Thank you for asking, Gary! This pre-primed board can be applied in a variety of interior applications, especially walls and ceilings. The high-quality priming allows for a broad selection of finished looks that enhance and complement any decor. It's recommended for interior use only. The radiata pine provides a stable, clean and warp free product.
A: Yes if you have a 1”x2” horizontally Ada backer to nail to
A: Bit hard to nail to studs if you go vertical. You could glue but these boards do tend to cup so may pull away. You could add horizontal furring strips and nail to them.
A: Absolutely, you can use it vertically. I used this on one wall and all of my ceilings. Highly recommend the product.
A: Thank you for your question Tammi, yes this can be hung vertically or horizontal for your in home project.
A: Yes. Run furring strips horizontally every 16-24” and attach shiplap vertically over that. I use construction adhesive & brad nails.
A: Boards are pretty light, you can carry about 6 at a time. Biggest thing is watching you dont have too much weight when you carry or they could snap because they bend so much. Also make sure to order extra if you are ordering online because the packing sucks and boards come broken in the box
A: About five (5) pounds. In a ceiling application like mine I nailed at each ceiling joist to avoid sagging. Looks perfect after three years and I installed about 900SF of it.
|Name||9/16 in. x 5-1/4 in. x 12 ft. Radiata Pine Nickel Gap Ship Lap Board||1 in. x 6 in. x 8 ft. Radiata Pine Finger Joint Primed Board||9/16 in. x 7-1/4 in. x 12 ft. Radiata Pine Nickel Gap Ship Lap Board||1 in. x 8 in. x 16 ft. Primed Finger-Joint Board|
|Nominal Product Length (ft.)||12 ft||8 ft||12 ft||16 ft|
|Board Joint Type||Shiplap||Square Edge||Shiplap||Square Edge|
|Coverage Area (sq. ft.)||5.28 sq ft||4 sq ft||7.2 ft²||9.67 ft²|
|Features||Finger Joint||Finger Joint,Paintable||Finger Joint||Finger Joint,Paintable|
|Nominal Product Thickness (in.)||1||1||9/16||1|
|View Product||View Product||View Product||View Product|