|Compatible Pipe Size (in.)||1/2 in.||Maximum Pipe or Tube Diameter (in.)||1/2|
|Minimum pipe or tube diameter (in.)||.5||Product Depth (in.)||2 in|
|Product Height (in.)||5 in||Product Width (in.)||2.2 in|
|Compatible Pipe Material||Copper||Pack Size||1|
|Pipe Cutter Type||Electric||Power Type||Manual|
|Product Weight (lb.)||.1 lb||Returnable||90-Day|
|Tools Product Type||Hand Tool||Type||Spin|
|Manufacturer Warranty||1-YEAR LIMITED|
A: The door is a bit tight on the when closing the 1/2" ATC12 around 1/2" pipe. Push a little harder and snap the door shut around the pipe.
A: The door is a bit tight on the when closing the 1/2 ATC12 around 1/2 pipe. Push a little harder and snap the door shut around the pipe.
A: Cuts 1/2 rigid copper pipe only
A: No, this will not work. The minimum pipe or tube diameter in inches is 1/2 as specified in the SPECIFICATIONS tab.
A: its size specific so you'll need cut under the welded joint.
A: You will need to cut above or below the welded joint as the joint will be too big to fit inside the ATC
A: Yes. You can buy a "replacement wheel" but I haven't done so as yet.
A: Yes but it never seems to work as good as if you just buy a new one.
A: No, the cutting blades/discs are not replaceable.
A: Yes the cutting wheels are replaceable. You can get a set of two cutting wheels, Catalog number ATC-W. The company is called General wire spring co. McKees Rocks, PA, 15136. 1 800-245-6200 or 412 771-6300.
A: Not that I can tell.