PN Series Solid Polycarbonate Sheet Door Fixed Awning (47 in. W x 31 in. D) in White Bracket

A:  Hello and thank you for your inquiry. I'll be happy to answer your question. The PN Series Solid Polycarbonate Sheet Door Fixed Awning comes in 47' in x 31.5' inch and 55' x 31.5 inch. With the dimensions that you provided of 45' x 31', both sized would work well for you, depending on the look and coverage that you are wanting to achieve. The awning will come with a manual that provides step by step installation that will assist you with the correct installation. Advaning recommends a minimum of 10-inch wall clearance as well as a 2-inch clearance from eaves or overhangs to best install either the PA or PN series polycarbonate awnings. The polycarbonate awning should ALWAYS be installed onto solid structure supports, brick or header. You will need the following: 1. Stud Finder 2. Pencil/Marker 3. Wrench 4. Level 5. Scissors 6. Mallet 7. Small Wood Block 8. Outdoor Rated Silicone Sealant 9. Ladders 10. Drill and Drill Bits *(Wood Install: 15/64 inch drill bit / Solid Masonry: 3/8 inch drill bit). A typical installation will require 2+ persons to complete. Specialty hardware for siding, cinder blocks, or solid concrete/brick can be found at a local hardware specialty store – Advaning always recommends consulting with a professional installer, contractor or handyman to best determine any additional requirements based on your specific installation site. Please review Advaning’s Polycarbonate Awning Guides for more in-depth information: https://advaning.com/wp-content/uploads/2022/12/ADVANING-PN-Series-Owner-Manual-PN.OM_.V04.2211.pdf There is also a Pre-Installation Guide to ensure that the PN will fit in the area that you are considering installing the PN Series Awning: https://advaning.com/wp-content/uploads/2022/12/Advaning-PN-Series-Pre-Installation-Guide.-V2212.pdf Please feel free to contact our team if you have any further questions. Thank you for contacting Advaning Awning. Kasandra W Advaning Awning

A:  Hello, thank you for your inquiry! I understand that you have a question regarding the spacing between the 2 brackets for the PN Series Door Fixed Awning. In reviewing the diagram for the PN Series, It appears that the spacing would be 45.2 inches apart. Please note that our diagrams are for general reference only, and they do have a data error of 2%. Thanks again for your inquiry, I hope this answers your questions. Best, Claudia, Advaning Awnings

A:  Hello, and thank you for your inquiry, please reference our dimension chart here; https://advaning.com/wp-content/uploads/2022/11/Advaning-PN-Series-Dimensions-Table-V.2211.pdf - Hope this information helps, please reach out directly for immediate assistance. Best, Chris. L ADVANING

A:  Hello and thank you for your inquiry. The 55" of mounting space is a suggested run length of clear unobstructed space for an easy installation. This measurement will provide 4" on either side to best install and maintain (when needed). I hope this fully answers your question, thank you. Best, Chris L. ADVANING