It probably will. I used it on three different circular saws. An 18 volt DeWalt, a 60 volt DeWalt, and an older model corded Craftsman.
The strips fit on the underside of the guide. The strip has an adhesive edge that sticks it to the bottom of the guide and the strip then extends past the edge of the guide. The idea is that the strip will prevent tear-out in the wood on the guide side of the blade.
50” long useful clamping length.
Yes, one section can do 4'.
No. The guide and the saw plate were purchased separately.
You could clamp this off square if you try. The tsquare just helps quick line ups. I don't use it. I just use speedsquares on each end to ensure that I am square.
You can purchase the Bora Track Clamps for angled cuts with this saw plate. If you need more help or would like to discuss this further, please reach out to our customer service team by calling, 1-248-588-0395 or emailing, firstname.lastname@example.org. Thank you, Affinity Tool Works | Bora
There should be no problem using the clamp as an edge guide for your saw. The sled is designed for a 7 1/4" circular saw and may not fit your saw but you still will benefit from the quick clamp edge guide..
The height of the aluminum extrusion is 5/8” and the width is 3”. Thanks!