6 in. x 6 in. x 4 in. Gray PVC Junction Box

Just a plastic box. It's good

I used this to house a RF remote control receiver and contactor for my dust collector. I copied the design from a YouTube video but I used the single remote control from Home Depot that cost only $10. I mounted the contactor and remote receiver to the base with screws and added some rubber feet. Attaching the mounting screws was difficult down in the box. The dust collector came with an infrared remote system that I disabled and replaced with the RF system.

Overall the box will work, but there's a lot lacking... First thing I noticed were the small flimsy mounting tabs which are definitely not made to hold anything more than the empty box. If it weren't for the fact that the box will receive additional support in this application through a rear-mounted conduit connection, I would have had to add more substantial mounting hardware. Second is a really huge deal and that's the use of plain cheap zinc plated steel screws for the cover that will undoubtedly rust, fail and render the entire box completely useless in short order. It cost me an extra $1.50 to purchase additional high quality stainless steel screws which should have come with the box in the first place. Third is the the cover gasket. While the gasket itself is good, it comes loose inside the box which means it's all deformed and nearly impossible to hold in place while trying to secure the cover! Much like the screw issue, this could have easily been remedied if the factory would simply affix the gasket to the cover with adhesive which we now have to do at the jobsite after the gasket has been permanently deformed. I have used a great many Carlon products over the years and I can say this one is sorely lacking when it comes to representing the level of quality that is normally synonymous with Carlon brand name.

WE are very satisfied using it as OEM in our two great Solar Energy products: Solar Turtle DC and Solar Turtle Super Charger. Further details are at www.adrijasolarandwind.com It is robust and made for outdoor and so we have chosen it. In nearly one year outdoor test of our products (this box is OEM of that) in Cleveland, we are very satisfied. Protected electronics and AGM battery inside perfectly. We recommend it strongly!- Adrija Solar and Wind !

I Make use of these junction boxes quite a bit. You're especially good Outdoors because of the weatherproof nature.

Sturdy. Side screw flanges great for mounting.

It’s a box. Not much to say

Well Made and good seal.