Fusion Pro #381 Bright White 1 qt. Single Component Grout

This product was easy to work with and it worked out well fast and efficient. The finished product looked beautiful. Very easy to work with.

I used this a year ago when grouting stone in my shower. I followed all directions, they say it's easy. I found that it sets up very quickly, luckily I did small areas. And it's very difficult to clean up, lots of wiping! Then 2 days later it was still soft, I waited about a week. I thought either the product is no good or I screwed up by wiping to much. So here is the main point, it dried super hard, looks great, no mold issues, no staining issues.For stone you must seal before grouting.

Easy to apply and clean up if you take the time to have several sponges to go over and over. Like anything else, it takes a little bit of effort and practice to get the hang of. I don't see how anyone could not like this product if they have ever grouted before just for the advantages compared to regular grout

Clean this thing is a nightmare. I have used this product for a while and every time I have to apply it I tell myself that I should charge extra because cleaning this thing is a nightmare when applying it and then the Haze too. Anyway I just wanted to express my frustration while I'm applying this thing in a shower knowing that I'm wasting time and money.

the grout does not work in lines easy and remains soft after hours and clumps during working. leaves the worst staining on tiles. i followed directions on sponge times and still had bad experience

You have to be patient, doing only 8-10 square feet of tile at a time. Watch some YouTube videos first, and don’t believe the nay-sayers.

This grout goes on easily and quickly. No mixing necessary, just dip out of bucket and apply. Only do small sections and watch “how to” video online, because it dries quickly. My best results were doing 18”x18” area and wipe down with clean wet sponges. Then wipe haze away with dry cloth staying out of grout lines. You don’t need to seal this grout. Very nice finish, just be sure to clean throughly.

Finish was like oatmeal, not smooth at all. My contractor had to cut the grout out and use a different brand. Not easy to work will never use again

This product is not easy to use, it’s a pain to clean and is labor intensive. I would pick any other product. And to add to it. Takes 7 days to cure!?!? Stains horribly!

I am 70 years old and have zero experience in bathroom remodeling, I had to change the rotten floor in my bathroom and I installed ceramics on the floor and walls, due to inexperience some of the tiles left me with different separations, I needed a grout with a sealant to avoid problems . I found FUSION PRO and took a chance. I was afraid of the work time because I get tired quickly so to begin with I grouted a 12-inch tile, I analyzed it and I didn't like cleaning it with water. By accident I left a part uncleaned and with a paper towel I managed to clean it. I gave up the sponge, the water and the fiber towel, I started the real work with a two-inch steel trowel to embed the grouting in the cracks as compact as possible, I only had about two inches of dirt left on each tile of the two that I joined With the grout, after three tiles were ready, I would stop and clean the residue by rubbing the dirty part with a sheet of kitchen paper towel: EXCELLENT RESULT. on the 5 by 8 foot bathroom floor I used less than a quart of Fusion Pro. It took me longer to get the grout into the groove than it did to clean.