Return this item within 90 days of purchase.
Get an answer now with AI
Magic Apron Assistant is an AI virtual assistant. By proceeding, you consent to the recording and use of your information by The Home Depot (and authorized third parties). More information
The DEWALT 90 Corner Clamp is built tough with the ability to clamp up to 200 lbs. of force. It's 3 in. D throat is a great choice for a variety clamping projects. This clamp directly mounts to your workbench allowing for ease during use.
Jaw Width (in.) | 3 in |
|---|---|
Throat Depth (in.) | 3 in |
Clamp Type | Corner |
|---|---|
Clamping Strength (lb.) | 200 |
Hand Tool Type | Clamp |
Individual/Set | Individual |
Material | Multi-Surface |
Maximum Opening (in.) | 3 in |
Returnable | 90-Day |
Tools Product Type | Hand Tool |
Manufacturer Warranty | Limited Lifetime Warranty |
|---|
No, the DWHT83840 corner clamp will not work to hold two pieces of 1" x 1" aluminum "L" angle for making a 45-degree miter cut corner.
It must be aluminum because a magnet won't stick to it.
The DeWalt DWHT83840 is a 12-inch (300mm) large trigger clamp. Materials: Bar: Made of reinforced steel for strength and durability. Jaws/Body: Constructed from high-impact, reinforced resin/plastic for toughness and resistance to deformation. Pads: The clamp pads are made of a non-marring rubber or thermoplastic material to protect work surfaces. Trigger/Handle: Typically made from reinforced plastic with ergonomic design for comfort and control. Summary: The DWHT83840 is primarily made of reinforced steel (bar) and high-impact resin/plastic (body and jaws), with rubber or thermoplastic pads.
The DWHT83840 is made of steel, however it has not been tested for welding steel tubing.
The DWHT83840 has a 3" throat depth.
Thank you for you contact. We apologize for any trouble or inconvenience in finding information. On this issue please contact DEWALT customer so that we can work together to get this resolved for you. Thank you for your cooperation in this matter.
Highly doubt it would work for that application
Not sure exactly what you need to do, but the clamp must have access to both the inside and outside of the material to be clamped. It does not work for a corner where only the outside is accessible.
Hello DIY2 Thank you for your contact. We apologize for any trouble or inconvenience in finding information. The clamps would not have been tested under those conditions by the manufacturer and would not be recommended. Best Regards Sherri C DEWALT
No, it does not work on 2x4s.
This DEWALT Corner Should Work on the Small Edge (2 inch side) of a 2x4 , though i doubt you could clamp it and pick it up and walk around with it, but hold them together securely enough on a flat surface to screw or use air nail gun on them .
The DWHT83840 will have 200 LBS of clamping force and a 3" throat capacity.
Would work good on small projects like boxes.
Viewing 1-8 of 11
4.2 out of 5