1/2 in. 0.710 OD Compression Coupling

A:  Yes that is what it is designed for

A:  Our compression coupling C43 is designed for poly drip tubing with an outside diameter of .710”. I would highly recommend contacting Mr. Landscape to make sure the tubing they manufacture is .710 OD. If you have any further questions, please contact our technical service/product support team at 1-800-322-9146.

A:  Yes, but your pressure must be at or below 25 psi anything above 25 psi and it can leak or possibly blow the tubing out of the fitting. If you have any more questions, please contact our technical service/product support team at 1-800-322-9146.

A:  The coupler you have shown here appears to be standard 1/2" dia. used in drip irrigation, insert about 1/2" it is easy to use. Push & twist at the same time to insert in coupling.

A:  .700 is plain black. .710 has a blue stripe (Toro brand). .710 has a much better life span.

A:  Most irrigation tubing has white labeling every 2 feet or so that gives the OD though it can be hard to read after weathering without magnification. Insert into coupling at least 3/4". Tubing in the image is 0.700" OD

A:  none is needed, easy to use!

A:  No tool needed, you just push hard and it will slide into the coupling, might even try a little vasalene.

A:  no!

A:  Vasoline

A:  .710 (blue stripe) is very difficult to get into the .700, but is possible.

A:  No. You just dip it in very hot water, and it goes right in