Yes, the Dremel 4485 Collet Nut Kit is compatible with the Dremel 200 Series. For further assistance, please contact us at 1-800-4-DREMEL (1-800-437-3635), Monday-Friday, 8A-5P CST.
I bought a set and yes it will fit 3/32" bit.
Please contact our Dremel Customer Service at 1-800-437-3635, Monday - Friday, 8am to 5pm CST for further assistance.
No it will not and because of the size of the quarter-inch drill bit you shouldn't attempt it's because you can burn out your motor or slide the bearings
The Dremel 4485 Collet Nut Kit is tested and recommended to be used with our Dremel tools only. For further assistance, please contact us at 1-800-4-DREMEL (1-800-437-3635), Monday - Friday, 8A - 5P CST.
It should fit the 12 volt Milwaukee rotary tool but I found that the center hole of my arbor had a rough spot in it preventing the collets from seating completely. I used a 11/64 drill bit to clean the center hole and now all collets, Milwaukee or Dremel, fit properly.
1/8 but I have ised it with 1/16 by wrapping some masking tape around the base of the bit.