The Dremel 220-01 WorkStation is not compatible with the Dremel 2050 Stylo+. For further assistance, please contact us at 1-800-4-DREMEL (1-800-437-3635), Monday - Friday, 8A - 5P CST.
Check Home Depot's shipping policies concerning out of country shipments. I'm a customer like you. I don't work for Home Depot.
Yes it does
Yes. Bring the drill press down to the hole in the base. install a drill bit to go into the hole. Loosen the screw at the back of the base. bring it around adjust the base by using a small ruler, measure on both sides meeting the drill bit. This should be accurate. Tighten the screw at the back of the base. If not, call 18004373635 Monday - Friday--8am to 5pm. This is the Dremel shop team, they might be able to answer your question more accurately. I hope this helps.
No: The Dremel WorkStation is for use of Dremel Rotary tools alone. The Rotozip is too large in diameter to fit in the tool holder. There is approximately 17 Dremel tools that can be used in the WorkStation. Other tools are either too big or small to fit in the tool holder. The workStation was designed for Dremel tools only. Sorry, but I hope this helps.
what Black & Decker rotary tool do have?
yes: there is a Dremel vise # 2500. that is designed to be used in the Dremel WorkStation. If you go on the internet and type in "small woodworking vises" you will see a multiple array of different woodworking vises ranging from $15.00 on up. There are very small vises that can be used on the Dremel Workstation. However you must find a way to clamp the vise to the work table. all vises come with slots on either side to clamp the vise down. Most vises come with , bolts nuts & washers to clamp the vise down.It is a lot better to make your own. If you go on the Dremel WorkStation web site,description, it will show you how to make the hold down clamps. I hope this helps. You can also call The Dremel Shop Team they will be able to give you more information. Good luck 18004373635
For further assistance, please contact us at 1-800-437-3635, Monday - Friday, 8A-5P CST.
The Dremel Rotary tool is held in place : removing the nose cap from the rotary tool. Insert the rotary tool into drill press , an secure it in place by tightening the clamp nut with clamp wrench. When clamping rotary tool in holder, make sure tool is seated properly and vent openings are not covered. Insert the power cord into the cord clips. This will keep power cord away from the work area. Make sure there is sufficient slack to keep the cord from being pulled tight when the full stroke of the drill press is conducted. The workstation is designed for use ONLY with Dremel Rotary tool MODELS; 100,200, 275, 285, 300, 395, 3000, 4000, 8100, 8200, 8220, 4200 and 4300. Your Dremel Workstation 220 will convert rotary tools to a drill press for ( DRILLING, SANDING, OR POLISHING, OR TO A FLEX SHAFT TOOL STAND). The Workstation is for use with one tool at a time. I hope this helps, there is more but this is all the space I have. I'll try some more? The drill bits are held in the tool by a collet system or Dremel 3- jaw chuck. The bit may be installed before or after the rotary tool is installed in the drill press. Good Luck.
All Dremel Rotary tools RPM range from 5,000 rpm to 35,000 rpm. one tool the 8100 range is 33,00 rpm. 35000, rpm is right now the fastest rpm on all its Rotary tools and can be used in the WorkStation as such. Good Luck