Weekend Warrior Iced Barnwood 3 MIL x 6-in W x 36-in L Peel & Stick Water Resistant Luxury Vinyl Flooring (21 sf/case)

A:  Hi Ccgirl - and thank you for your inquiry. Yes the DuraDecor Weekend Warrior Iced Barnwood Peel & Stick can be installed on sheetrock / Drywall walls. Be sure to follow the wall installation guide when doing so. This can be found under the product details tab then installation guide tab -https://www.homedepot.com/p/DuraDecor-Weekend-Warrior-Iced-Barnwood-3-MIL-x-6-in-W-x-36-in-L-Peel-Stick-Water-Resistant-Luxury-Vinyl-Flooring-21-sf-case-DD7572/311913884 Thank you-

A:  Hello Matt53 - thank you for your inquiry. Listed under the "Additional Resources" section - "Installation Guide". We recommend reviewing and reading these instructions prior to starting your project. As far as the wall prep - I've copied and pasted below on those very steps. Wall Requirement: All walls must be dry, without signs of any moisture or moisture damage, mold or mildew, be clean, without contaminants like dust, grease or any other bond inhibiting material, smooth, without holes or ridges and flat to a tolerance of 1/8-inch over 6-foot and 3/32-inch over 1-foot in any direction and be structurally sound. Holes, seams, cracks, and voids, etc. in existing dry-walls must be filled with an appropriate gypsum-based patch or joint compound and sanded smooth. New drywall or repairs must be primed using a suitable PVA primer and allowed to fully dry/cure before installation. Existing painted walls should be lightly sanded using fine sandpaper or steel wool, then wiped clean with a damp cloth and allowed to dry. New plaster and paint must be at least 30 days old, to allow it to cure properly. Clean new plaster with diluted vinegar and water (1-1) and allow to dry. Dirt and grease must be removed by washing with a suitable detergent and warm water, then be allowed to dry. Unsuitable Surfaces: Do not install DuraDecor over any wallpaper or wall covering, flaking paint, adhesive of any type, or any other unstable surface. Including chipboard, OSB, luan plywood, mahogany-based plywood, Masonite™, finished or pre-finished paneling, or varnished finishes cement board, fiber-based backing boards, cinder block or brick, or any other non-underlayment grade panel; oil-based enamels or similar paints; primer sealers or primer stain-blockers. Hope this helps answer your questions. Thank You!

A:  Hello Megiddo - Thank you for your inquiry. Installing on top of Glasliner, which from our determination is similar to FRP board / panels, is not recommended. Most FRP board is textured, therefore would not be suitable to adhere to. If it's smooth, the best approach is to do a bond test. A vinyl bonding primer would also be needed. If the FRP board / panels are in a environment such as a bathroom or kitchen, and depending on moisture or temperature, the vinyl planks will more than likely fail. Ordering a sample piece of the planks would be the best option to test prior to ordering a whole carton. Hope this helps answer your question. Thank You -

A:  I would imagine that it could be. It is peel and stick with strong adhesive. 

A:  Hi Kelly, Thank you for your inquiry. It is perfectly acceptable to install the Iced Barnwood Peel and Stick over linoleum providing the linoleum is well bonded to the subfloor, clean, dry and free of contaminants. You must also use a primer before installing the Peel and Stick. Thank you-