|Arbor size (in.)||0||Blade Length (in.)||7.75 in|
|Blade Thickness (in.)||0.09||Product Depth (in.)||0.2 in|
|Product Height (in.)||2 in||Product Width (in.)||2 in|
|Fits Brands||ECHO||Fits Models||ECHO PE edger models and PAS edger attachments.|
|Returnable||90-Day||Used with Equipment Type||Edgers|
|Manufacturer Warranty||90-day consumer / 30-day commercial|
A: Hi Steven! Thank you for your inquiry. The size of the cotter pin is 2x22.
A: Hi Jared! The arbor size is 25mm. For additional information on the edger blade, please visit the following link, https://www.echo-usa.com/edger-accessories/edger-blades
A: 1 inch
A: I don't have a torque wrench, but I just tighten them down... never had an issue of them loosening or even coming off.
A: There is no specific torque setting for the nut when replacing the blade on the Echo edger. Tighten the nut snugly until you reach the point where the cotter keyhole through the shaft aligns with the keyhole in the nut without overtightening. Then insert and set the new cotter key by spreading the cotter key ends. Now you are ready to use your new blade!
A: I will be honest since I did not own a torque wrench until recently; I just tighten the nut fairly snuggly, to help pressure the retaining washer, and then install the pin.
A: Hi there! Thank you for your inquiry. ECHO has not tested the Edger Blades on other manufactures products. ECHO is unable to confirm if the blades will be compatible on other products that are not ECHO products. I'm sorry for the inconvenience.
A: Yes they do