It doesn’t matter which side you have facing out but if there is print on one side, it should face down for aesthetic reasons.
No, it must be installed as instructed by the manufacturer. Mike
yes – it is a 10x25 roll but it is folded and rolled up.
please check with your local Home Depot store or the Pro services desk
it is a 10x25 roll but it is folded and rolled up. So, the diameter of the roll at retail is 8”.
No, it is not recommended to put shingles over this product.
Please review the installation as this needs to be applied over a flat service. The slip of the roof will be a factor too. Finally, you will need primer and adhesive. But it is imperative that you check the installation instructions which are available online located under Product Overview / Info and Guides / Instructions & Assembly.
It weighs 102 lbs per roll.
EPDM should be bonded over 5/8" plywood, 5/8" OSB board, ½” Fiberboard or polyisocyanurate board with a fiberglass backing. The plywood or OSB board should be sanded to eliminate sharp edges, thoroughly cleaned, dust free and dry.