2 in. x 2 in. x 10 ft. Galvanized Steel Drip Edge Flashing in White

Thank you for your question. This item is only recommended for roof slope of 3/12 pitch or greater. There is no way to guarantee that water will not get underneath.

I believe the easiest and best way to obtain anything from Home Depot is to download The Home Depot app and Order your items for store pickup. You can check local stores to see availability of any product. You can then order that product from a specific store located in your area and if the product is not in any of the local stores then you can have it delivered to your house for free. It's a super easy way hassle free and customer service is always great!!!

Thank you for your question. Nail this down we do not recommend screwing this to your roof.

Thank you for your inquiry. Please visit this link which leads to the product page for the 3 in. x 3 in. x 10 ft. white flashing: https://www.homedepot.com/p/Construction-Metals-3-in-x-3-in-x-10-ft-Galvanized-Steel-Eave-Drip-Flashing-in-White-RE33WH/202400142. To determine a products inventory level at your local Home Depot Store you will need to call your local store or use their online shopping tool and type in your zip code. This will help determine if your local store has this item in stock.

Both sides are coated in white.

Yes

Yes since it is relatively thin gauge it can be bent to any angle, however to make it look nice you would need to make a jig in order to get it to the right angle and for it to remain flat and square. Best bet would be to take it to a sheet metal guy and have him do it but that will cost a few bucks. It can be bent over the edge of a sturdy metal or wood bench as well but getting it to look professional will be a bit of a chore. If finish isn't to concerning, then should be OK to DIY.

Yes this product can be bent.

Yes, just make sure paint is OK for metal applications, but most are.

Yes, if it is exterior paint then it is fine. The flashing is paintable with any paint but will not last long if it is not for exterior.

Yes good paint should stick just fine.

Yes

It is designed to be attached using self drilling metal roofing screws, which also have a small rubber o-ring just under the head of the screw to prevent water from leaking through screw hole when attached.

This flashing does not have any pre drilled holes and yes it's installed with roofing nails.

It is designed to be mounted with self drilling sheet metal screws that have a rubber o-ring under the head of the screw to prevent water penetration. The screws come in a myriad of colors to match metal color, and are also available at Home Depot. They come in different lengths so choose the right length depending on what you are screwing into and if the old shingles are still on, and metal is applied over top of it, make sure to use at least a 1/2" longer screw than if there is no shingles, so it can penetrate into the wood below the shingles. Do not over torque the screws during installation or you run the risk of them back out over time due to thermal expansion and contraction that is normal in all roofing applications.