Portwood 60 in. LED Outdoor White Ceiling Fan

You can actually feel the breeze this fan creates. Great air flow. Couldn’t be happier.

I purchased 2 of these for my patio in May 2018. They've worked beautifully and pushed a ton of air. They get a moderate amount of use and never at high speeds because they push a lot of air. 2+ years later we started noticing a scraping noise from one of them and then occasionally it would stop or now want to start without a push. You could hear the motor when you turned it on so we weren't sure what was up. We also noticed that there was an uneven gap between the outside of the motor assembly housing (below the part the fan blades slide into) and above switch housing. Knowing that at the height of our Arizona summer I did not want to be without and that any warranty service would want all or part of the fan returned, I purchased a duplicate. When I had it installed, the electrician noticed that 8 of 10 screws (2 for each blade) that attach the 5 fan blades to the motor were missing. These screws come installed by the factory and use a specific screw driver end to tighten them. When installing the 5 fan blades, you screw 3 regular screws to attach the fan blade to the bracket. Basically only 1 of the 5 blades was still attached correctly. The 2 screws were out of the other 4 brackets. There is something that attaches that bracket deeper inside the housing but it doesn't hold it tight so without the 2 screws factory install screws in place the bracket (with blade attached) floats freely and also causes the housing to drop down some. It was the fact one was still attached properly that was causing the uneven kilter to that housing and hence the scraping and stopping. In order to check these particular screws from time to time, you would need to disassemble the light kit and the switch canopy to be able to few inside the motor housing to check for these screws. IF YOU FIND screws on the ground anywhere around these fans, that's what they are from! I have included pictures below of everything I'm talking about.

Good speed with good airflow. Silent operation.. LED lights are of good quality. Highly recommended product.

Great fan blowing speed, just a little wobble.

The fans are for my outside porch. It has two settings 3000/4000 k for the LED light and the 4000 is pretty strong. It has 4 controls of light (pulls). The fan looks pretty fancy and good quality material. The max fan speed ( CRM 9333 )is strong and has 4 fan speed controls!! Easy to install and Good price. Fans had been installed for almost 2 months, so far so good. If anything changes I will update review. Visitors had asked me for the Fans, they like it. Very pleased and satisfied with this purchase to include the color I choose (Espresso Bronze)! Love it!

Very Good

So far so good! Installed 2 of these fans in our covered patio using 4’ downrods. Wired the fans together but separated light/fan controls (no remote). One switch turns on both lights, another switch turns on both fans. The fans are quiet, they don’t wobble or hum, and put out plenty of air. Only issue was having to drill new safety holes in the downrods as they wouldnt screw far enough into the fans to allow using the predrilled holes, but thats a downrod issue, not the fan.

We purchased 2 of these for the covered patio on our new home. The fixtures fans are beautiful and fit into the decor well. They have also held up well so far (a little over a year now). Even though they are not directly in the sun, with the Southwestern heat in the summer fan blades tend to sag even after the first summer, but we are not seeing any of that yet. We had our electrician on our build install them, and the only drawback is that these cannot be hardwired to have the fan blades on a separate switch from the light (which leaves us 1 dead switch). We would have loved to be able to control the blades and light separately from our inside switch, but that's not the case with these fans. But overall we are happy with our purchase!

The best fan I ever had! Installed two outdoor in my lanai to replace nice decorative fans that did not produce much airflow as well as one in my office. The blades in the package are presorted by weight that eliminates the need for balancing after installation. Powerful and quiet. Just make sure to also purchase an extension rod and Cathedral Ceilings installation kit (Model # 82715 Store SKU #232831) if you install on a cathedral (angled) ceiling. Click on the image for full image.

Installing the blades is a giant pain. Because the blade and screw holes end up being very close, it might take a while to install the blades. Also, it is HEAVY, super heavy. The light on the dim. For my great room, I need at least 3000lm (I had 3 900lm bulbs on the fan that i replaced with this one). This lamp is nowhere near that. Interestingly looks like they have removed a very useful feature on the more recent model. I have two units of this fan. One was purchased 3 years ago. It had a nice feature where you could just flip the main light switch multiple times to dim or brighten the light. This one no longer has that. What a disappointment. Now I have to use the small pull string to change the light brightness. :-( Air flow has also decreased from ~10500+CFM to 9500CFM (not a big deal but still it is step down). FWIW, I did not notice much change in the airflow between the two fans.