1 qt. Premium Paint and Epoxy Remover

My go to brand of stripper. Have been using this brand for many years. Easy to apply.

Worked great to remove spray paint from a steel frame.

[This review was collected as part of a promotion.] I really like this product. I use this for my crafting mess ups. I make cups that have epoxy on them and when the epoxy messes up or something happens to the cup and I don't like how it looks and need to start over, I use this to clear off the epoxy. This product stripps multiple layers of epoxy in minutes. Which is great for me because it takes so long to make cups and one mess up can lead to a week behind of these products i make so timing is everything to me. I have tried multiple products but this one seems to work the best!

This is the best stripping product I've used by far. Forget the orange stuff this works fast. Took all the white paint off this piece. Results are fantastic.

We moved into a house with close to 2,500 sq ft of Satillo (terracotta) tile that was “sealed” with polyurethane 35 years ago. The polyurethane had turned amber and had 35 years of dirt and grime ground in. I tried every conventional stripping product and nothing worked. A sane person would have given up and tore it out or covered it, but I kept searching. Finally I saw another stripper manufacturer recommended this product for terracotta tile since there’s was unsuitable. Hallelujah! Though this product is technically “not recommended” for floors due to vapors, I have been literally stripping one tile at a time, 6 per hour, up to 36 tiles per day, off and on for 6 months, with long pauses for other projects, and am about half way through the house. If anyone else is crazy enough to try this (hopefully on a smaller project) I have perfected a technique that works for our 12” tile: pour a 3 inch puddle of stripper in the center of the tile, use a 1” paint brush to spread it evenly over the tile, wait a couple of minutes to let it work, scrub the grout and tile with a nylon grout brush, wipe up the stripper with 2-3 select-a-size paper towels, repeat all of the above with a smaller amount of stripper, then final wipe with 2-3 slightly damp grout sponges, wipe with towel. After allowing up to a week to fully dry, I then seal with 4 coats of Behr wet look sealer. I have attached a photo that includes before, stripped (but still drying) and sealed, and 2 others that show the dining room before/after.

Just what I needed. Wished it came in smaller can. My project was very small. (Two wall metal hooks)

If one is seeking a quick and not too toxic solution to their paint removal project - this IS the product needed! Our "fancy" linoleum was partially covered with splashes of paint from a remodel project (no matter how much we tried to cover it thoroughly). Spraying is an easy task - no damage to linoleum. Less than 10 minutes - it was ready to wipe off with a paper towel. Clean, no surprises. We, additionally, used it on Liquid Nails - took a few sprays over the course of 30 minutes - all became actual liquid and came off like a jello. Apply in well-ventilated area. RECOMMEND!!! A+

I received the JASCO 1 QT. PREMIUM PAINT AND EPOXY REMOVER to test for Home Depot. I have worked in the past doing furniture refinishing and this is not what the pro's use. That being said, it works fine and is much more forgiving on your skin and work area. Relatively low fumes and does a good job. You still need to use gloves and good practices. It does the job. Please see the pictures below that I did on a test piece of wood.

The Jasco 1 gal. Premium Paint and Epoxy Remover is an extremely strong stripper that effectively removes most coatings. It is safe to use on wood, metal concrete and masonry. The semi-paste formula is great to use on vertical surfaces. After your project, this stripper cleans up with water. Strips up to 5 layers of latex paint in 15 minutes. Strips up to 5 layers of oil/alkyd paint in 45 minutes. The product takes quite a while to work and if you have more than 5 layers of epoxy, latex or oil / alkyd paint you will disappointed. As it will take several applications to remove the paint. Note: The scrapper and plastic bristle brush that I used started to melt, get soft and lose strength. A better brush and on masonry a metal scrapper is recommended.

I was really amazed at how well this product worked in 15 minutes or less. If you don't want the mess of brushing on the stripper this product is perfect. The paint was really tough on the door I was stripping and it took the paint right off. I was really happy with the results and with the convenience of just spraying it on. It almost illuminates one step. I would recommend this product!