A: The base is 13"x18", but there are 1" tabs on the short sides that allow you to bolt the base to the floor, meaning you will need to set up your mobile base to 13"x20" to accommodate the tabs.
A: 13"x18", but there are 1" mounting tabs on the short sides that allow for mounting the jointer to the floor, so you will need to set up a mobile base to be 13"x20".
A: With Jet, you have to pay attention to the stock numbers. In this case though the Jet stock number on the company website matches the "model number" on the Home Depot site:708457DXK. So I think there is a very good chance that the Home Depot one has the high mounted on off switch. Also most Jet tools are shipped direct from the manufacturer. In which case you can be certain that you are going to get the one pictured on the Jet website with the same stock number. Home Depot rarely answers the questions posed here. Home Depot does have a centralized customer service phone number. I've called it before. You might try asking there. You might try calling Jet. Personally, I would just go ahead with the purchase. The stock number is good enough for me. But then, I have a slightly older version with the stop switch on the front, lower down. I think they sell that high mounted switch is an accessory though. I know you can get them from third parties. Good luck with the purchase. I'd stay away from the helical head. But think about 8 inch if you can afford it.
|Name||1 HP 6 in. Woodworking Jointer with Quick-Set Knive System, 115/230-Volt, JJ-6CSDX||6 in. Jointer with Stand and V-Helical Cutterhead||54A 115-Volt/230-Volt 1 HP QS KNVS Jointer||54HH 115-Volt/230-Volt 1 HP 1PH Jointer|
|Voltage (volts)||115 V||110 V||230 V||230 V|
|Maximum Board Width (In.)||6 in||6 in||6 in||6 in|
|Horsepower (HP)||1 hp||1 hp||1 hp||1 hp|
|Product Width (in.)||56 in||47.5 in||24 in||24 in|
|Product Height (in.)||45 in||42 in||37.5 in||37.5 in|
|Maximum Speed (RPM)||6000 RPM||5000 RPM||6000 RPM||6000 RPM|
|View Product||View Product||View Product||View Product|