If your band saw has tapped holes in the front side of the table, then it should fit. At the worst, you may have to add one hole to the rip fence bracket to make it fit.
This rip fence will fit just about any major brand band saw out there. If it doesn't fit your saw exactly, the most you would have to do is drill (1) hole in the mounting rail to make it fit. The only way that it would not fit at all is if there were no tapped holes in the front edge of your saws table.
Thank you for your inquiry. That Bandsaw is not on our compatibility chart. That does not mean that is will not fit. You may have to drill holes in your table top to match the mounting holes or drill new holes in the guide rail to match the holes in your table top. Also you want to make sure the top is strong enough to support the Fence.
Thank you for your inquiry. That Bandsaw is not on the compatibility chart. That Saw may fit with some modification to the rail or tabletop of the Bandsaw to make it fit.
I have one on my 14 inch bandsaw table. I just looked at it and it does not appear that it would be able to attach to a 10 inch table. The part that attaches to the table has bolt holes 11-1/2 inches on center; that would not work for a 10 inch table. Contact Kreg and I bet they have a product for you.
Yes, this item will fit a 14 inch band saw.
Assuming it's one of the 14" Jet saws on the compatibility chart, it should work fine. That compatibility chart can be seen here: https://www.kregtool.com/webres/Files/pdf/BandsawFenceCompatibiltyChart.pdf
Yes this does fit. i have one on that exact bandsaw. Only issues are that you can not open the lower wheel door all the way since it hits it. You also have to remove this to change blades. Even with that it works well.
Thank you for your inquiry. That Saw is not on the compatibility chart. That does not mean it will not fit. If the holes do not match between the Fence rail and your table top there are a couple things you can do. You will just need either drill holes in the tabletop to match the holes in the fence rail or drill new holes in fence rail to match the holes in the tabletop.
Yes, this should work with either product