A: Its a tri grab holding bit on the impact so all the bits have hex ends on them with small necks before the drilling bit, they have hardened tips on all the bits so when they run they don't grab on little abrasions on the bit as quickly. Just makes using them more comfortable on the wrists, and the bits last longer. Ranges from Phillips to Flat to Hex, assortment comes in Imperial/Metric standard sizes for Makita bits. Be careful to ensure the bits you are getting in the pack include the right set of standardized sizes for what you intend to use them for because 10 MM (World Standard) is not the exact same as the imperial (US and 2 other countries) equivalent and might be too large/small and cause problems with your threading.
A: Thank you for your question on the T-01725 bit set here is what’s included. The 70-Piece Impact Drill-Driver Bit Set offers a full range of solutions for drilling, driving, and fastening. Includes the most widely used screwdriver and nut-driver sizes and a magnetic 3”-bit holder and nut drivers provide extra-strong fastener retention.
A: Thank you for your question on the T-01725 impact drill bit set. Yes, they are compatible with 1/4" impact drivers and 3/8" or 1/2" driver/drills.
A: They are not interchangeable. The impact drill will use only the impact bits, whereas the common drill can use both, though may damage them over time.
A: Thank you for your question on the T-01725.This kit is compatible with 1/4" impact drivers and 3/8" or 1/2" driver/drills.
A: Yes, the 6095D has a 3/8" chuck and will accept the bits in the T-01725 Contractor-Grade Bit Set, 70-Pc.