Steel 2 Wood Fence Bracket Project Pack WAP-238 (50-Piece per Box)

A:  Hello, The remarkable 2-3/8″ WAP-OZ Fence Bracket features “Fasten-Ready” technology, which means each bracket comes complete with four hex-head wood screws and two carriage bolts, PRE-INSERTED into the bracket and ready to go. Another cool point is that they’re all a standardized half-inch size, so you don’t have to change drill bits as you go… so no more hunting through the bolt bin, counting pieces to make sure you have enough for the job and the 2-3/8″ Steel To Wood 90°Brackets make corners a breeze! Using any of the WAP series of fence brackets makes quick work connecting 2-in (2-3/8-in outside diameter) vertical metal pipe posts to wood fence rails. Please visit OZCO's site at www.ozcobp.com for more information https://ozcobp.com/product/wap-oz-steel-2-wood-fence-bracket-single/ Thank you for your inquiry.

A:  These worked beautifully on my 2⁷/⁸ piping. So yes!

A:  Unfortunately I don’t know the sizes of the pipes It was used for the fence but I think the bracket can fit a 2 7/8 these brackets will last for ever they are very well made

A:  Hello, No unfortunately that size pipe is too large for this bracket. Thank you for your inquiry.

A:  This is 50 sets of brackets with 200 screws, 100 bolts and 100 nuts. Nothing additional needed to install. These brackets are wonderful, allows mounting stockade fence on 2 3/8" metal posts and with treated stringers (2x6 split in half, 1.5 x 2.75") allows easy section hanging and replacement. I use 4" TimberLOK screws (available at Home Depot) to attach fence to stringers. At 3 brackets per post will do 15 sections of fence.

A:  The set contains 50 brackets, along with the screws and nuts to finish the job. They work great and are very sturdy.

A:  Box of brackets sufficient for fifty, 50 post attachments. Very good product

A:  All hardware account for 50 bracket setup including screws, nuts to accommodate final install

A:  yes full fifty set with all need for fifty times

A:  50 sets of brackets.

A:  This was 50 complete brackets, so you’ll end up with 500 actual pieces of metal

A:  The brackets measure 0.100 thick, 10 gauge.

A:  These particular ones seem to be a little thinner Guage but I found them to work just fine. I've ordered corner brackets separately and they're a thicker gauge. The thicker gauge is better for corners but on a straight run these work fine. Close tolerances grip the pipe good.

A:  The package I got does not have the gauge thickness on it.

A:  I can’t speak to gauge but the thing is sturdy , easy to use . Will bend or distort if you wind it up tightly but I didn’t break any of the 100 or so I used. I think it is a very good product.

A:  Don't know the gauge, but they are plenty thick to do the job more than adequately.