3-Ton All-in-One Bottle Jack/Jack Stand

A:  I would think it would be too tall for a Honda CRV and wouldn't fit underneath it

A:  Is too low

A:  Honda CRV is 10in at the jack point. Measure your vehicle at the proper jack point to avoid damage to your frame.

A:  if its tall enuff to go under it it should work

A:  Check the listed minimum jack height and the clearance under your car at the jacking point...

A:  I looked over the jack carefully. Nowhere does it say where it is made. It has a couple of labels on it. The language would suggest maybe Mexico, but I don't know. It does exceed ASME specs. and I haven't had any concern about the quality. The lock mechanism is sometimes a little hard to work but it does the job.

A:  China

A:  China..

A:  This work good

A:  jack stats states its 12.25in .

A:  This model has a lift range of 11''-21''.

A:  I measured it. Barely clears 11 inches. I measured 10.9 inches from floor to top.

A:  It fits under my Subaru Forester. Works great .

A:  Yes it will..

A:  This jack states it is 12.25in high. My small suv at the jack point is 10in from the ground under the sidesill.

A:  It works fine by driving the car over a 2x6 board and rest the wheel over it.

A:  does not fit under sedans with out first using the factory jack to raise the car up high enough

A:  No, it does not. Does not fit under my cross-country wagon either. I can still use it, but only after I raise the vehicle high enough with the hydraulic jack

A:  No. It fits under most SUVs, but most Sedans won't have the clearance for this thing. Especially considering that you'll want to put in the area with a flat tire yielding even less clearance.