#1 Home Improvement Retailer

Internet # 100117949

Model # 6700-1

Store SKU # 694389

Store SO SKU #1001371185

1 Gal. Indoor/Outdoor Carpet and Artificial Turf Adhesive

$36.35
Apply Now
Pay $11.35 after $25 OFF your total qualifying purchase upon opening a new card. info
Apply for a Home Depot Consumer Card
  • For indoor and outdoor carpet
  • Compatible with a variety of substrates
  • Up to 48 hours curing time
  • View More Details
Store
0 in stock
icon
Free & Easy Returns In Store or Online
Return this item within 90 days of purchase. Read Return Policy

Product Details

About This Product

ROBERTS 6700 adhesive was designed for exterior or interior carpet installation and is a solvent-free for reduced health risks, a lower environmental footprint and high initial grab. This non-flammable adhesive may be used in areas where flammable adhesives pose a health risk due to fumes or flashback fires. Use this adhesive to adhere most indoor/outdoor carpets with polypropylene, rubber-backed (foam, marine, waffle), urethane and tufted, woven or non-woven/needle-bond backings.

Highlights

  • For adhering most indoor/outdoor carpets and is ideal for decks, sunrooms and basements
  • Bonds with concrete, APA rated marine grade plywood, aged asphalt paving (hot applied), fiberglass and aluminum when surface is clean and roughened to promote bonding
  • Suitable for indoor and outdoor use
  • Moisture Control Adhesive - up to 5 lbs. MVER and 80% RH
  • Up to 30 minutes open time, 60 minutes working time and 24 to 48 hours curing time
  • Approximately 65 to 75, 90 to 110 and 100 to 120 sq. ft. per gallon coverage for smooth, polypropylene/woven, and non-woven/rough-backed carpet installations respectively
  • Suggested for use with a 1/8 in. x 1/8 in. x 1/8 in. U-notch trowel, 1/8 in. x 1/8 in. x 1/16 in. V-notch trowel, or 3/32 in. x 3/32 in. x 3/32 in. V-notch trowel depending on carpet installation type
  • Enviro-friendly, solvent-free and LEED compliant; VOC < 1 g/L, SCAQMD Rule 1168
  • Protected by GoldGuard, an antimicrobial protection system that inhibits the growth of mold, mildew and odor causing bacteria in both wet and dry adhesives
  • CRI Green Label Plus Certified - GLP no. 36471
  • Non-flammable for safe use
  • 10 year direct bond limited warranty
  • Recommended for covered exterior applications
  • May be used for artificial turf if the turf manufacturer suggests a latex based, full spread adhesive application
  • Return Policy

Product Information

Internet # 100117949

Model # 6700-1

Store SKU # 694389

Store SO SKU #1001371185

Specifications

Details

Color Family

Beige

Container Size (gallons)

1 gal

Returnable

90-Day

Turf Tool Type

Adhesive

Warranty / Certifications

Manufacturer Warranty

To be free from manufacturing defects

Questions & Answers

187Questions
caret
Q:Will this adhear marine carpet to ABS plastic?
by|May 13, 2024
1 Answer
Answer This Question

A:  The best option and most available is a solvent based product such as DAP WELDWOOD. Epoxy based adhesives, MS polymer, and Urethanes will bond with ABS as well. We always advise you to consult the turf manufacturer for adhesive recommendations before proceeding. Customer Care

by|May 13, 2024
    caret
    Q:I am soundproofing a room with two layers of 5/8" drywall. This product was recommended as a lower cost alternative to a product called "Green Glue" because it remains flexible, transfers sound waves to heat energy. Does this remain flexible?
    by|May 2, 2024
    1 Answer
    Answer This Question

    A:  We do not have an adhesive in our current product line that is specified/warranted for use in vertical applications. Customer Care

    by|May 3, 2024
      caret
      Q:How much adhesive is typically used for the 177 square foot coverage with the VEVOR marine carpet - that this product would be used with?
      by|Apr 27, 2024
      1 Answer
      Answer This Question

      A:  If the carpet backing is rubber this would fall under a smooth backed carpet category, and you would use the 1/8x1/8x1/8 trowel and get 65-75 sq ft per gallon. Please note, this adhesive will not work with vinyl backed carpets. Customer Care

      by|Apr 29, 2024
        caret
        Q:What do I use to remove old, glued down rubber carpet backing from deck?
        by|Apr 26, 2024
        1 Answer
        Answer This Question

        A:  We do not have a product in our line for this application. You may try Sentinel Adhesive Remover, but please check with that manufacturer prior to using. Customer Care

        by|Apr 26, 2024
          Showing 1-4 of 187

          Customer Reviews

          4.1 out of 5

          • 4.1 out of 780 reviews
          • 78% recommend this product
          Filter by:
          Showing 1-10 of 780 reviews
          Contracter
          Very good product to work with wait time is less than other brand
          by
          • Verified Purchase
          Worked perfectly for outdoor roofing project
          We used this product for an unusual project - gluing "grass" outdoor carpet to the roof of our screen porch to reduce the noise of rain and falling nuts. Due to our roof having a composite composition we wondered if it would work - and it did! Very, very pleased with the results. No more TV-drowning noise from the roof!
          by
          • Verified Purchase
          • Recommended
          The product worked as expected.
          The product worked as expected.
          by
          • Verified Purchase
          • Recommended
          HORRIBLE PRODUCT
          Followed instructions and used on outdoor carpet on covered porch! The glued bled through the gray carpet leaving white marks all over! Ruined a 12 x 25 piece of carpet. Would not recommend this adhesive!
          by
          Response from The ManufacturerAug 11, 2020
          Roberts understands installing a new outdoor floor covering can be challenging. Here are some key product usage points regarding the 6700 adhesive that may improve performance and satisfaction. Adhesive bleed through is most commonly caused by the adhesive field lacking the appropriate amount of open time. During the installation process- after the adhesive is applied to the substrate, the adhesive will need to stand open for approximately 20-30 minutes prior to the carpet entering the adhesive field. This ensures the adhesive doesn't filter through the carpet backing and into the fibers. This also ensures the adhesive builds bond strength and promotes the curing process over the next 24-48 hours. - Bailey Customer Care QEP
            • Recommended
            8 found this review helpful
            Great Product! Works as intended. Package was damaged, however product was OK. We will see in tim...
            Great Product! Works as intended. Package was damaged, however product was OK. We will see in time how well it holds up...
            by
              • Recommended
              Worked great on my boat carpet
              Worked great on my boat carpet
              by
              • Verified Purchase
              • Recommended
              2 found this review helpful
              This product worked great for attaching indoor/outdoor carpet to my cellar stairs. I cut the car...
              This product worked great for attaching indoor/outdoor carpet to my cellar stairs. I cut the carpet to fit the full tread with enough carpet to fold over the front. Then glued it to the top of the tread only and let it dry. Once dried I turned the front edge and and stapled it to the underside with a pneumatic stapler. Very happy with the clean look.
              by
              • Verified Purchase
              • Recommended
              2 found this review helpful
              Easy to apply, I used a paintbrush. Used a layer of about a 1/4 inch. I clamped down the starting...
              Easy to apply, I used a paintbrush. Used a layer of about a 1/4 inch. I clamped down the starting point and rubbed the carpet over the adhesive and let it set over night. It was ready for wear after that. Clean up was pretty simple for hands you just lightly scrubbed with soap and hot water.
              by
              • Verified Purchase
              • Recommended
              1 found this review helpful
              I used CV this to adhere large upholstery sections to plywood panels for the interior of my 1967...
              I used CV this to adhere large upholstery sections to plywood panels for the interior of my 1967 van project. Easy to spread, easy to reposition if needed. Very low odor. Good value and performance.
              by
              • Verified Purchase
              • Recommended
              2 found this review helpful
              i'm floored that this is the best way to put on carpet glue. make sure you have a lot!! and it's ...
              i'm floored that this is the best way to put on carpet glue. make sure you have a lot!! and it's not cheap. corners don't stay you need a very thick coating to get a full adhesion. overall very dissatisfied with the process.. laminate counters and contact cement to me sounds like a better way to go
              by
              • Verified Purchase
              4 found this review helpful
              Showing 1-10 of 780 reviews