A: Hi Lauren, We are sorry to hear about this. Please reach out to us at https://www.surfaceshields.com/submit-a-case/. We will review the issue and offer the best solution for the removal. Thank you.
A: Hi Carol Carpet Shield is not recommended for Upholstered furniture. Carpet should is a temporary 30 day solution for synthetic carpet only. We are happy you checked with us first! Thank you!
A: I wouldn’t do it. It will leave a sticky residue if you leave it on for an extended period of time. Works good for its intended use however.
A: Easy Application Steps for Carpet Shield® Remove over wrap from the product and locate the start of the film. Pull film off the roll slightly to determine the direction the film unwinds. Place film sticky side down on the carpeting, secure start of the roll by applying slight pressure and then push roll in the desired direction. Apply slight pressure over the top of the film as you roll out to the desired length and cut with a utility knife or sharp edge. To remove simply lift film up at an edge, pull off and discard. Before using, the purchaser and/or user must determine suitability of this product for the intended use and the purchaser and/or user assumes all risks and liabilities is connection therewith. Because there are so many variations in carpet fibers and products used to prevent carpets from staining, it is imperative that the user of this product determine suitability. To determine suitability test Carpet Shield® on a small portion of carpet that is in a non-exposed area. Leave Carpet Shield® in place for at least 48 hours and then inspect to ensure there was no disturbance to the carpet fibers. Use only on completely dry carpeting. If carpeting was recently cleaned allow for at least 48 hours for carpeting to dry and cleaning agents to dissipate For any newly installed carpeting do not use Carpet Shield® for at least 72 hours to allow adhesive vapors to dissipate completely through the padding and the carpet If subjected to extreme conditions of temperatures exceeding 95o F, direct sunlight, heavy foot traffic or outdoor exposure, it is recommended Carpet Shield® film be inspected and replaced with new material more frequently and as needed Do not use in extreme humidity conditions or high moisture areas like basements Use on synthetic fibers only. NOT for use on oriental carpets or wool carpeting Carpet Shield® is for temporary protection up to 30 days, REMOVE ON 30TH DAY or sooner
A: It did not leave a sticky residue to the carpet, but if it did on wood after leaving for more than a few days.
A: Thank you for contacting us. We are sorry to hear that! Our Carpet Shield has a Water-Based adhesive. We recommend using a citrus-based soap pretreatment with a HOT water extraction to remove any residue. Please make sure it is not STEAM, but a HOT water extraction.
A: Hello! Thank you for contacting us. This roll weighs 2lbs.
|Name||24 in. x 50 ft. Carpet Protection Self Adhesive Film||X-Paper 36 in. x 100 ft. Roll||Floor Protector Clear 2 ft. 2 in. x 11 ft. Waterproof Non-Slip Clear Design Indoor Protector Runner Rug|
Save $15.78 (35%)
|Flooring Material Features||No Additional Features||Moisture resistant,No sealing required,Stain resistant||Stain resistant,Waterproof|
|View Product||View Product||View Product|