Since 1808, we’ve been trusted to provide tools that have tempered-steel strength and enduring quality.
Our durable snow tools can help you clean up what winter has left behind.
Light, heavy or ice-packed snow -we’ve got a tool for every situation.
Gentle on decks and pavers.
Nylon blade is wear-resistant and non-stick.
Great for breaking up frozen, hardened snow to lift and throw.
Light-weight and durable.
True Temper snow tools help you remove snow and slush quickly throughout the winter season.
Pushes light to medium snow and slush. Good for ice-packed snow.
Ideal for scooping light to medium snow and slush. Good for ice-packed snow.
High capacity for pushing and scooping large amounts of snow and ice.
Remove snow and ice without harming your car’s surface.
Help prevent structural and water damage to your house from heavy snow.
A: 1/4 of an Inch it's a nice shovel heavy duty handle it will last a long time for a Homeowner
A: There is no metal strip on the bottom. On a rough surface it will wear down a bit
A: What metal strip? Mine didn't have one. It's just a plastic shovel.
A: Unfortunately, wear strips on poly snow shovels are not replaceable. The steel wear strip actually adds to the life of these shovels vs. the blades without steel wear strips.
A: I bought this shovel & it’s the BEST shovel I’ve ever used. Totally worth the money!!!
A: No metal edge on this blade. Very thick plastic. It’s getting a little rough on the leading edge, but will continue to do a great job pushing snow. Not as good at scraping the packed/icy stuff.
A: I had called the manufacturer and at that time they did not sell replacement parts for this product and you would have to purchase a new shovel. However My shovel had an issue with the handle connecting to the shovels blade assembly and they sent me a replacement new shovel.
A: Tried it once, did not like it, should’ve returned it! Snow too heavy to push due to shovel size, May be better if shovel is smaller.
A: I did not get an answer from home depot in time, so I did place the shovel blade in a table vise and used a flathead screwdriver and hammer and the blade was fired off. I bought a new wooden handle same radius as the original, and screwed the keyway onto the new handle, drove it back onto the blade, and good as new.
A: The nature of your question is not clear, but I think what you might be asking about is an issue I encountered. The shaft of the handle was only loosely inserted into the brace on the blade when I bought it. To tighten the two together, turn the shovel upsidedown and firmly bang the handle on a hard surface. This will seat the blade onto the handle's shaft.
A: As far as I can see, once the handle is inserted it locks into place and I don’t see any way to release it. Maybe you can contact (the manufacturer) True Temper and see if they will sell you a new handle and blade mount, if so you could switch the blade over.
A: It does wear down. But it was cheaper than the full metal version. Also the metal really hurts a lot more when you hit a crack and does weigh much more.
A: Not good for uneven pavement.. it really likes to get caught on cracks.. works if you go slow and lift over bumps.. it won’t where out.. strong as hell..
A: The blade is pretty thick and durable. It will get caught in an uneven drive depending on the width / depth. I found that it was able to slide over my asphalt driveway pretty well. The blade is also removable, so I am assuming you will be able to replace if you experience a lot of wear.
A: I suggest it's intended for a large smooth driveway. Works great with a few inches of snow (but not a lot of deep snow!). It did not like our brick-paved patio which has high-low spots. Overall a nice snow removal and gets the residual snow off after using your shovel(s) or snowblower.
A: Yes, my driveway is all asphalt and quite large. Just cleared it again and had zero problems. Actually, the metal edge shovels hang up occasionally but not the pusher.
|Top Rated||Top Rated|
|Brand||Bully Tools||True Temper||True Temper||Alpulon|
|Name||30 in. Steel Snow Pusher with Fiberglass Long Handle||30 in. Industrial Grade Snow Pusher with Versa Grip||36 in. Industrial Grade Snow Pusher with Versa Grip||51 in. Metal Adjustable Handle Plastic Snow Shovel Rolling Pusher|
|Blade Length (in.)||10.5 in||8.5 in||8.5 in||12.5 in|
|View Product||View Product||View Product||View Product|