14 in. Sun Tunnel Tubular Skylight with Rigid Tunnel and Pitched High Density Flashing

VELUX Sun Tunnels are ideally designed for small spaces, such as bathrooms, laundry rooms and hallways. However, this product will function similarly to a recessed electric light, so we would not expect it to interfere with your TV.

yes you can cut the length to be shorter.

yes, diffuser lens comes with this kit. model TGR-THR TMR IF NOT CALL THIS # 1 800 888 3589 PART IS PRIMARY DIFFUSER AND SECOND DIFFUSE. OR EMAIL TO MELODIE.WOODS@VELUX.COM DON'T FOGET YOUR ADDRESS GOOD LUCK!

you can ask pro desk

Hi Chuck. This component is approximately 17 inches in diameter.

As a contractor I installed some of these and found cracks in flashing at attachment points a few months later. I was able to use roof tar to seal. I am still hoping it doesn’t come back to bite me later. Would not use these again.

The short answer is YES! VELUX Sun Tunnels with rigid tubing will have an upper and lower elbow that will help you adjust to the roof and ceiling angles. The upper elbow actually attaches to a pivoting ring within the flashing that will give you more of a straight run than you think is possible.

Regarding the tube skylight, almost anything manufactured can be altered or adapted to fit a slightly different purpose than the original design of its use. However, keep in mind that whenever you adapt something, you increase the risk of problems. In this case, it also could void the manufacturer's warranty. This product is made to be installed on a sloped roof, so in my opinion, as a roofer of over 30 years, I would recommend that a box be built over the opening on the flat roof that would be flashed and sealed. This box would be flush with the roof but have a slope at the top of it so that the tube skylight could be installed on a slope and then flashed and sealed properly. To attempt to install the tube directly over the flat roof, I believe would be a mistake, unless the manufacturer makes an adapter kit for that very purpose. So, the flat roof would have a circle cut in it the diameter of the skylight tube and the top of this angled box would have a circle cut into it the diameter of the tube skylight. Then, the top edges would extend a few inches beyond that circle in each direction to allow room for flashing to be installed and sealed with roof cement. Be absolutely sure that the bottom of the box, that portion that is in contact with a flat roof, is also properly fastened, has appropriate flashing and roof cement.

no problem, good to go. the tube come with 48"

Hi JJ. Choose the TMR 014 Sun Tunnel for this purpose as it has a pitched aluminum base/flashing. Here is the link to that item: https://www.homedepot.com/p/202844251 Please contact VELUX Customer Service via email to receive instructions for installation procedures for this type of roofing material. Send this request to: vcustomer.service@velux.com