Questions and Answers for Hampton Bay Tavish 24 in. 3-Light Brushed Nickel Classic Vanity with Frosted Glass Shade

A:  24" W x 5" H

A:  Yes this fixture should come with everything to install. If you are missing anything please call 1-800-228-6197

A:  Yes, it came with everything you may need including wall anchors! Installed in just a few minutes. Used 60 watt bulbs and it's bright!

A:  The information on the package is only an average minimum. Usable wattage can vary widely, based on your system. We used a Russian electrician and he installed a dual 3-ring system that allows us to use 6 washers and dryers at the same time (expensive but gets the laundry done quick.) So we use 4 400-watt bulbs in the Hampton Bay Tavish vanity light in our bathroom. We use mercury vapor bulbs on the outsides and sandwiched between them are 2 heat lamps. The room gets real toasty in the winter and it's bright enough that you can easily read in the light from the bathroom window 50 yards away from the house at night. However, I would suggest using a commercial fan system and safety glass in your shower door because the bulbs tend to explode if there is too much steam in the room.

A:  According to the manual, up to 100 watts

A:  My whole unit rusted in 3 1/2 years.

A:  Contact the manufacturer listed on the label.

A:  No, the screws are not covered by the warranty. Mike

A:  This fixture does not come in 5 lights.

A:  I ordered this for small powder room and it worked out great. H D has them in most configurations from one light to 10.

A:  No 3 lights

A:  No.

A:  Any bulb with an E27 base will fit.

A:  Just asked my handyman as he installed the light fixture. He answered “yes”.

A:  The light bulb holds the glass shade in place, very securely. The shade has a lip that rests against the socket, and when the bulb is screwed in the shade is stabilized.

A:  This fixture comes with installation instructions.

A:  There is a nut that holds globe to fixture. For me the ratings started from 2020 and I purchased these back in 2011. I'm purchasing them again for another project

A:  small screws hold the globe's on the fixture. We started remodeling our last house 2013/2014, we have since sold that house.

A:  Have no idea why rating start and when, but there is a thread with a locknut that holds Globe to fixture. Goes in before light bulbs.

A:  Screws apply pressure to hold them in. And to my knowledge, yes, it's been made for a while. We bought ours 4 to 5 years ago.

A:  The width for the 4 light is 30 inches.

A:  5 inches

A:  30 inches

A:  Don't understand your question, but: The bottom (bell shape) of each glass is 6 in wide. The width of all of them, combined from the first to the fourth, is 28 and 1/4 in

A:  About 2 foot wide.

A:  It's perfectly safe.

A:  Yes, since led bulbs are rated the equivalent wattage to a standard incandescent bulb yet only using a small fraction of the electricity.

A:  Just asked my handyman who put these lights in for me. His answer is yes to the LED bulbs question.

A:  Not sure about the store, check. This is the info from the fixture's manual. Call customer service team @ (877)527-0313. Refer to SKU (261-568) OR UPC (046335947481)

A:  You could ask someone at a store - but to my knowledge, they do not sell these shades independently of the full light fixture.

A:  Yes, the H D has a wide selection. They are not expensive and you may want to change out all for a new look.