Yes! Your electrician is correct! You have to use the wired light as your first light in the chain. You use the plug wire from it to plug into the sensor switch, then the link wire to the first light and so on
Hi - I called and they said it could only be used with the plug-in fixtures. It does not work with the direct wire fixtures.
Hello Homer, thank you for your question. That is not correct. The inline motion switch uses power directly from the direct-wired fixture, that is why it goes inline between the fixtures. If you have any other questions, please give us a call between the hours of 7 AM – 8 PM Central Standard Time, Monday thru Friday at 1-800-654-8483, press option 4
Thank you for your question. This is a hand gesture motion sensor, so 2-3 inches away from the sensor is all that's needed. If you have any other questions, please give us a call between the hours of 7 AM – 8 PM Central Standard Time, Monday thru Friday at 1-800-654-8483, press option 4
Mine don't turn off until I move my hand over the sensor.
Hello Brenda, thank you for your question. The light will stay on as long as it detects motion. Once there is no motion detected the lights will turn off after 20-30 seconds. If you have any other questions, please give us a call between the hours of 7 AM – 8 PM Central Standard Time, Monday thru Friday at 1-800-654-8483, press option 4
I have reported the above answers because they directly contradict each other. The Tech Support answer looks wrong to me. I cannot imagine why it would turn the lights off after 10-30 secs of not detecting motion. It’s a hand motion sensor switch!!