Questions and Answers for Zinsser 1 gal. B-I-N Shellac-Based White Interior Primer and Sealer

A:  Happy to help! When using Rust-Oleum Zinsser B-I-N Shellac-Based Primer on exterior surfaces, even with enclosed porches, it can be used as a spot primer only. We recommend using this primer to spot prime knots in the wood prior to priming the whole surface with Rust-Oleum Zinsser Cover Stain Oil-Based Primer. This will ensure lasting results with the B-I-N Primer. https://www.homedepot.com/p/Zinsser-Cover-Stain-1-gal-White-Oil-Based-Interior-Exterior-Primer-and-Sealer-3501/100398377 - Rust-Oleum Product Support 3

A:  Thank you for reaching out! Our Zinsser B-I-N Shellac-Based Primer may be cleaned from applicators using acetone, denatured alcohol, ammoniated detergent or 99% isopropyl alcohol. If any spills or drips have dried, use denatured alcohol or ammoniated detergent to soften and remove the primer. - Rust-Oleum Product Support 2

A:  Check out this YouTube video Proper Paint Brush Cleaning - Paint, Polyurethane, Varnish, Shellac https://www.youtube.com/watch?v=Tf_GkLQQjFA

A:  Thank you for reaching out! Each gallon of Rust-Oleum Zinsser B-I-N Shellac-Based Primer has a recommended coverage of up to 500 square feet. The coverage rate will be dependent on the porosity of the surface and the application method. - Rust-Oleum Product Support 3

A:  Great question! Yes, Rust-Oleum Zinsser B-I-N Shellac-Based Primer can be applied directly to metal surfaces. - Rust-Oleum Product Support 3

A:  Happy to help! While Rust-Oleum Zinsser B-I-N Shellac-Based Primer will adhere to this surface type, we do not recommend this primer for use on flooring. This product will not withstand direct foot traffic and is also not recommend for use on floor paints. It can be used on subflooring prior to applying new flooring, such as tile, wood, or carpeting. - Rust-Oleum Product Support 3

A:  Great question, Jean! While Rust-Oleum Zinsser B-I-N Shellac-Based Primer can be used on particle board, when used on flooring material, it is for subfloor use only. This means that the primed surface must have flooring material used over it, such as wood flooring, tile, carpet, or vinyl. This primer cannot be used on a floor under a floor paint or epoxy. - Rust-Oleum Product Support 3

A:  I would not try this. It is shellac based so like an oil paint if you try an overcoat that is latex based you may get very poor results. Supposedly you can paint a latex over oil based primer, but I have had failure to bond with a latex over oil based product. Stock with like kinds.

A:  Great question, Sandie! Yes, Rust-Oleum Zinsser B-I-N Shellac-Based Primer can be used on interior paneling surfaces. This primer can then be topcoated with oil or water-based paints after 45 minutes. Make sure to apply a topcoat within 3 days to ensure full adhesion. - Rust-Oleum Product Support 3

A:  Great question, MaryJane! Rust-Oleum Zinsser B-I-N Shellac-Based Primer can be applied to the exterior of the fireplace. We do not recommend it for use on the inside, as the exposure to an open flame and the high heat will cause the primer and any paint over it to blister and peel. At this time, we do not offer a product that we can recommend for use inside a fireplace. - Rust-Oleum Product Support 3

A:  Thank you for reaching out, Jason! For lasting results, we recommend repairing the surface as much as possible prior to applying Rust-Oleum Zinsser B-I-N Shellac or any coating to the surface. This primer can then be topcoated with a paint of your choice. We recommend Rust-Oleum Transformations Cabinet Paint. https://www.homedepot.com/p/Rust-Oleum-Transformations-1-gal-Pure-White-Cabinet-Paint-369864/315070235 - Rust-Oleum Product Support 3

A:  Happy to help! Zinsser B-I-N Shellac Based Primer can be applied to plywood flooring before laying peel and stick vinyl tile. Allow the primer to cure for at least two days before laying the tile. - Rust-Oleum Product Support 13