Customer Reviews for Halex #6 - #2 Service Entrance (SE) Wedge Clamp Connector

I used this with network cables cat 6 + messanger works great, I did 2 cables with one Halax #6-#2 for each cable.

Yes this wedge took the stress off our wires!

Worked out great. Heavy winds snapped a large branch onto cable lines and broke the old wedge clamp wire.

Worked very well - had communication and power lines far in heavy snowfall recently - and the insulators were pulled from the house. I was able to use these to attach to the support cable for power to auxiliary buildings and attached directly to communication lines support cables (integral to CoAx and Fiberoptic, and external to ‘old Copper’. Would definitely use again -

This wedge clamp was perfect for this project.

Needed a smaller size.

Rating provided by a verified purchaser

Rating provided by a verified purchaser

This item was exactly what I was looking for ,and did exactly what it was intended for. Easy to use .

Was just what I need to run some 12/2 UF overhead from my house to a shed in the back yard.

These are great for holding the bare wire on a typical 100 amp service entrance. Easy, simple and effective. They’re plenty strong for the job.

Works great! Would have gotten five stars if it came with instructions or at least a diagram.

Ran an aerial electric service out to my greenhouse. Exactly what you need on each end of the run

Rating provided by a verified purchaser

Held that wire up real good.

Good stuff, making overhead wiring much easier.

Rating provided by a verified purchaser

Rating provided by a verified purchaser

Great Clamp, I have 23 acres of land with a lot of 70 foot Oak Trees and my electricity runs in the air secured on the side of a bunch of trees and needed to re-run about 100 feet of electric so I needed these clamps to secure the metal messenger of the electric cable to the trees.

wedge clamp worked as expected

Easy to install (15 minutes). Worked perfectly for the cable tv line going into my house.

I used it for a flat fiber optic cable which it's not made for (it's made for coax) but it worked well because the cable went up the flat area and wedged there. Took a lot of strain off the cable.