1/4 in. x 7 in. x 8 ft. Cape Cod Beadboard Planks MDF Boards (3-Pack)

Very easy to install and looks great.

Waste of time and money. Tried installing the long 8 foot pieces vertically on a wall. It’s impossible to fit the tongue in the groove of these floppy flimsy pieces. Infuriating. Avoid this product. Will be returning the remaining pieces

Gives a great look to any room!

Out of 5 packs not one wasn't damaged in some way. Any slight imperfections in the tongue or groove and there is no way its sliding together. Nothing but semi expensive frustration

I purchased the planks to replace oak paneling around the back side of my cabinets. I was planning to install against the cabinet framing but figured out that the planks need be nailed/glued to a solid surface. So I first installed ¼” door skin over the framing. Also I purchased the base and top molding kit that goes with the planks but decided to install my own molding. I did used the base molding to keep the planking straight and at the same height during the installation and I highly suggest using the base molding for the install even if you plan to use different base molding. The planks are easily installed but make sure you use a level after each plank is inserted. We painted the planking and the finish product looked fantastic. It says to leave a 1/32” gap between the planks but I just inserted each plank and bumped the new piece against the previous piece until snug. I definitely recommend this product.

Being MDF, this stuff is a little tender and you have to be careful with the tongue and groove sides. Also, I had one panel where the groove was jammed with paint, but that was one that I had to cut anyway. Besides that, it went up pretty easily and is overall a great product to work with. I wouldn't hesitate recommending this to anyone.

I went to take down old 12"x 12" ceiling tiles and found the person who installed them used about a tube of glue on each ceiling tile. So went to plan b put up firing strips every 12" over the existing ceiling then nail gunned the breadboard to the fir strips. Putty all nail holes and caulked around the crown molding then painted. Wife is so pleased with the results. Had a little issue with tongue and groove damage but nothing we could not work around by using damaged as cut pieces. The store was great about taking back any badly damaged pieces. Project came out excellent looks 100 percent better.

I used this product for a basement ceiling and encountered problems I didn't expect. When the ends were butted against each other I found that the thickness has varied which doesn't have a very good appearance. I was hoping for a nice flush and smooth appearance across the entire ceiling. The other issue is that the ends on some of the pieces were rough and slightly damaged which magnified the previous issue.

For my project this product had the best overall appearance vs the 4’ x 8’ panels.