2599 11/16 in. x 1-5/8 in. x 8 ft. Primed White PVC Shingle Moulding

There are several manufacturers that produce fasteners specifically intended for use with cellular PVC. (See list below). You can also use fasteners designed for wood trim. They should have thin shanks, blunt points and full round heads. Fasteners should penetrate 1½” into substrate. Fasteners should be positioned no less than ¾” or more than 2” from end of boards. Fasteners must be weather resistant, such as stainless steel. For interior trim, such as casing, base, quarter round and crown, use 16 gauge finish nails, 6d or 8d finish nails. Pneumatic guns can be used ‐ rubber bumpers on the nail gun tooling will protect the moulding. Air pressure should be adjusted based upon gun, temperature, substrate (80‐100 psi is typical). Always use the least pressure necessary to drive the nail into the product.).Trim should be fastened to a flat solid surface. In cold weather below 40°F, predrilling may be necessary. Do not use brads or wire nails. Staples can only be used to fasten beaded planking. Recommended Screws:  Fasten Master Cortex® Hidden Fastening System (screw and PVC plug system)  Starborn Pro Plug® System (screw and PVC plug system)  Simpson Strong‐Tie® Trim‐Head Stainless Steel Screw  GRK Fasteners FIN/Trim Finishing Trim Head Screws (ClimatekCoated® or Phoenix Stainless Steel)  Kreg Blue‐Kote ™ Pocket‐Hole Screws (for assembling trim with pocket‐holes)  #8 gauge TrimTop 305 SS with sharp type 17 piercing point by Fasten Master  305 SS Headcote #7 or #8 trim screws with auger points

The length on this item is 8'. Thank you

Check the width of item. If good I do not see any obstacles. Never stop improving.

This can be painted any color you like. You can use this as it is. I have left mine as they are; however, I am using this item as a picture shelf.