Pipe Decor 1/2 in. Black Iron Pipe Flange (2-Pack)

A:  hi Jack, I have purchased many of these a few at a time. I created a wall shelving system that has grown a few times. These are hard to find in stock. I think they are a big seller. I just keep going to my local HD to see if there is any in stock. a couple of times I ordered them online and went to pick them up. When I got there they hadn't filled my order yet, so I had to wait for someone to go into the stock and fill my order. Remember these come in 2 finishes! I hope this helps! Michael

A:  Hi Jack, unfortunately, this Pipe Decor 1/2 in. Black Iron Pipe Flange (2-Pack) appears to have been discontinued and is no longer in stock or available for purchase on Homedepot.com. The item will remain briefly on the website for customer reference, and the description will be updated with “Discontinued” if it has not been already. There may be stores with remaining stock to be sold; however, you will need to contact your local Home Depot store for availability. Thanks for shopping Home Depot!

A:  I had the same problem and found a whole display in the plumbing aisle. I had to go to the store.

A:  Thank you for your inquiry. This item has been replaced with store sku 1002654605 which is available online for a lower price.

A:  I had it shipped along with some pieces of pipe for a shelf unit I was making.

A:  Maybe they are out of stock? I ordered mine online and had it shipped to my home.

A:  Yes I was able to get them in the store. They were in a separate location from the regular plumbing flanges.

A:  They had these available in the store as well as on line when I purchased mine

A:  I have bought many of these and I have only bought them for each fitting in the pack!

A:  When I bought them, the price was for a two-pack, not individual fitting.

A:  The price is for the 2pack

A:  The price is for a pack of 2

A:  The price was for two fittings. Much less expensive than buying each fitting alone,

A:  I used #10 screws sand they fit flush.

A:  #10

A:  #10

A:  I used No.10 flat head screws and it worked perfectly (see pic). No.8 may be too small for the hole.

A:  I used 8s but I'd imagine 10s would be large enough too