A: Hi there! Thank you for your inquiry. you can use Spark Plug: NGK BPM- 7A or 7Y. If you are not be able to obtain the recommended sparkplug, a Champion CJ-7Y may also be used.
A: champion bpmr 7a
A: Rommie, you need a 14mm socket
A: You'll need a 19mm deep socket or scrench for this Echo spark plug. No idea why RickP says you need a 14mm???
A: Hello! Thank you for your inquiry. A 19 mm socket or scrench is needed for removal. Only remove the spark plug when the engine is cold. Removing spark plugs from a hot engine with an aluminium cylinder may cause the threads to strip out.
A: Hi Jigger! Yes, the Spark Plug Kit, Part #90114Y, is compatible with the SRM-230.
A: Yes, you need a BPM8Y sparkplug. This is the replacement you need.
A: Hi JIM! Thank you for your inquiry. The Replacement Spark Plug, Part #90114Y, comes with the NGK BPM-8Y. If your ECHO Chain Saw requires that part number then this kit would work for you.
A: I had the same problem, I bought the BPMR8Y and it worked out fine.
A: It's been said on several chainsaw forums, that the resistor helps protect the electronic tune module that the newer saws have. Don't know if that's true, but it can't hurt. I'm in the opposite position, I have trouble finding the resistor type
A: "R" is for Resistor. Resistor spark plugs prevent electrical interference that can disrupt car radio reception, two-way radio and cellular phone operation. If your unit requires an NGK BPM-8Y than the NGK BPMR-8Y can also be used.
A: The Leaf blower
A: The PPF-2100 is not compatible with the Spark Plug Kit, Part #90114Y. The PPF-2100 requires the spark plug, NGK BPM-7A or 7Y.
A: The spark plug needed for the CS-490 is, NGK BPM-8Y.
A: The spark plug needed for the CS-590 is, NGK BPM-8Y.
A: To remove the spark plug from your ECHO product, turn the spark plug counter clockwise using a 19 mm socket or scrench. The spark plug boot can be removed by simply pulling up on the boot. The boot is not held in by anything else. If you still require assistance, feel free to contact ECHO's Consumer Support Department at 1-800-432-ECHO (3246).
A: You will need a deepwell socket wrench, but you won’t need to buy a whole new socket set. You can buy special spark plug sockets individually. Just be sure to get the right size—an answer to another question said that it’s 19mm. You will also need something to turn the socket and give you leverage, so you’ll have to buy another ratchet, or socket wrench. Again, socket wrenches come in a few sizes. Most likely you’ll want a 3/8, but check it with your new spark plug socket to be sure they work together. As for getting the boot off, I would first try it while you are wearing gloves. They grip better than bare hands. Twist it around a little to loosen any corrosion and wiggle it back an forth some. If that doesn’t work, try using a pair pliers, just don’t squeeze any harder than you have to.