A: Thank you for your question. Loctite PL Concrete Non-Sag Polyurethane Sealant is specifically designed for use on concrete and may not be compatible with some roofing materials or applications. We recommend testing for adhesion, compatibility and suitable and acceptable results before starting your project. You can also reach out to our technical helpline at 1-800-624-7767 to share the details of your project so we can assist you.
by|Mar 27, 2024
Q:Can you fill holes in brick and then drill screws into it
by|Feb 27, 2024
1 Answer
Answer This Question
A: Thank you for the question. Loctite PL Concrete Non-Sag Polyurethane Sealant may or may not be well suited for the application described and understanding this may clog the drill bit, depending upon the sealant thickness. In this situation all you can do is try understanding results are not guaranteed. You might consider using an epoxy, depending on the nature of the project.
by|Feb 28, 2024
Q:Can you fill gap between concrete step and porch.
by|Feb 14, 2024
1 Answer
Answer This Question
A: Thank you for the question. It is possible to use the Loctite PL Concrete Non-Sag Polyurethane Sealant for the project described depending on the size of the gap. The maximum recommended joint width for this product is 1.5 inches (38 mm).
by|Mar 9, 2024
1 found this answer helpful
Q:Can I use this to repair stucco cracks?
by|Jan 29, 2024
1 Answer
Answer This Question
A: Thank you for the question. Loctite PL Concrete Non-Sag Polyurethane Sealant may be used on stucco for the project described, depending on the dimensions of the cracks.
by|Jan 31, 2024
Q:Can you paint on and when
by|Jan 27, 2024
1 Answer
Answer This Question
A: Thank you for the question. Loctite PL Concrete Non-Sag Polyurethane Sealant is paintable once fully cured. The cure time is approximately 7 days or longer, depending on temperature, humidity, porosity of the substrate, and the amount of sealant applied. For more information on our product, please visit www.loctiteproducts.com and review the product technical data sheet.
by|Jan 29, 2024
Q:Can I use this to seal leaks around a water pipe through the concrete foundation?
by|Jan 10, 2024
1 Answer
Answer This Question
A: Thank you for the question. Loctite PL Concrete Non-Sag Polyurethane Sealant is designed to seal interior/exterior gaps and joints in concrete and masonry and may or may not work for the application described depending on the size of the leak and the composition of the water pipe. As to whether it can stop your leak will depend upon the nature of the leak, its origin, and what the root cause may be. There are no guarantees for this intended use and the sealant may only provide a temporary fix and not completely resolve the situation. We recommend that you refer to the products Technical Data Sheet at www.loctiteproducts.com for more information regarding joint design and prep.
by|Jan 12, 2024
Q:I have a crack in an exterior brick wall on my house, is this product good to use to fill the crack???
by|Dec 21, 2023
1 Answer
Answer This Question
A: Thank you for your question. Loctite PL Concrete Non-Sag Polyurethane Sealant may be used depending on the size of the crack. The maximum recommended depth this product should be used in is ⅜ inch (10 mm) and the minimum is ¼” (6 mm). The maximum recommended joint width is 1.5 inches (38 mm). For deep joints, the sealant depth must be controlled by closed-cell backer rod or expansion joint filler.
by|Jan 10, 2024
Q:How do you prepare the foundation to put the ceiling in? Do you have to feed it out at all?
by|Dec 1, 2023
1 Answer
Answer This Question
A: Thank you for the question. Because it is unclear what you are asking, we recommend reaching out to our technical team at 800-624-7767 so we can assist you.